Zitrek cnp 15-2 091-0016 [28/37] Page 28

4-2. Move the speed control lever from the LOW to

the HIGH position. When the engine speed reaches

approximately 2,300-2,600 PM, the centrifugal R

clutch engages. If the engine speed increased very

slowly, it is possible that the clutch can slip. Do not

operate the speed control lever slowly. Fig-9, 10

OIL ALERT SYSTEM

The Oil Alert System is designed to prevent engine

damage caused by an insufficient amount of oil in the

crankcase. Before the oil level in the crankcase can

fall below a safe limit, the Oil Alert System will

automatically stop the engine (the engine switch will

remain in the ON position).

! NOTICE

If the engine stops and will not restart, check the

engine oil level.

4-3. When compacting asphalt, it is advisable to paint

the bottom face of the vibrating plate with diesel

fuel.

This will assist in preventing the plate from sticking to

the asphalt.

4-4. When shutting off the vibrator, turn the speed

control lever from the HIGH to LOW position. Do not

move the speed control lever slowly.

5. Transportation

5-1. Be sure to stop the engine while transporting.

5-2. Screw up the fuel tank cap securely and close the

fuel valve to avoid fuel leaking.

5-3. In transportation by car, fix machine securely not to move nor to fall down.

In case of driving for long distance or at off -road, take out fuel from tank.

6. Shutdown

To stop the engine in an emergency, turn the stop switch to the OFF position.

Under normal conditions, use the following procedure:

6-1. Set the speed control lever at the low speed position and allow the engine to run at

low speed for 2 or 3 minutes before stopping.

6-2. Turn the stop switch to the OFF position. Fig-12

zitrek