YLI YK-168 [3/4] Operation of the control station

www.yli.cn

We create security

A. Single User Code (Common User Code)

PRESS KEY 5 00 Enter the User Code (4-8 digits) #

Deleting the common User Code

When enter new common User Code the old one will be deleted automatically

B. Multi-User Codes

PRESS KEY 5 01 Enter the User Number (3 digits) Enter the User Code (4-8 digits) # (Confir-

ming the code length) (Green LED flash) # (Green LED stop flash) (confirmed entering is completed)

NOTE: 1. If continue to record more User Codes, at the end of each recording, it is no necessary to press the

key # per each time, to repeat the above steps until all User Code recordings are finished. Finally to press

the key # to confirm all recording are completed.

2. The User Number of the User Code and the User Number of the User ID Card must be the same,i.e.the User

Number of the User Code is 008,the User Number of the User ID Card is also 008,so in Card + Code

operation mode the User Number of both the User ID Card and User Code can be matched in application.

Deleting the User Code recorded (Multi-User Code)

PRESS KEY 5 02 0000 # (Deleted all the User Codes)

PRESS KEY 5 02 Enter the User Code to be deleted # (Deleted the User Code)

PRESS KEY 5 02 Enter the User Number of the User Code # (Deleted the User Code of the User

Number)

OPERATION OF THE CONTROL STATION

(8)Programming User Code entry mode

(User Code entry mode)

PRESS KEY 70 0

(Manual entry mode, have to press the key follow the User Code entered to

confirm the code length of the User Code entered. The User Code can be 4-8 digits)

PRESS KEY 70 1 # (Auto entry mode, the User Code must be set in the same code length as the

program code. No need to PRESS KEY # to confirm the code length of the User Code entered.

The User Code can 4-8 digits)

NOTE: Factory setting anual code entry mode

(9)End of programming

Exit programming mode in 60 seconds

PRESS KEY to exit programming mode and return to normal operation status(Standby mode)

NOTE: The amber LED 1 flash in 2 second interval-the control station is in normal operation mode,

standby for use.

(1) Open door by User ID Card (Door opened by reading User ID Card)

(2) Open door by User Code (Door opened by entering User Code)

(3) Open door by User ID Card User Code (Door opened by reading User ID Card, green LED will flash,

in 10 seconds entering the User Code)

SAFETY FUNCTIONS

(1) Entry of 10 false codes or reading 10 invalid ID Cards, the control station locks for 30 seconds.

(2) In case tamper switch is activated, warning signal is indicated: amber LED continuous flash and

buzzer continuous beeps, until tamper switch is deactivated.

Control station in locking state:

No response to ID Card / or key entry, amber LED and green LED show 1 flash and buzzer sounds 1 short

beep in 10 seconds interval, at the end of locking the buzzer sounds 1 long beep to signify the end of locking

and return to normal operation mode.

RESTORING THE DEFAULT PROGRAMMING CODE

If the programming code is lost (or unknown), use the DAP jumper to restore the default programming code,

procedures as follows:

(1)Disconnect power supply.

(2)Put the DAP jumper from OFF position to ON position.

(3)Reconnect power supply, amber LED will flash constantly and the buzzer will beep constantly.

(4)Put the DAP jumper back to OFF position, amber LED will stop flashing, buzzer will stop beep.

(5)The default programming code 1234 is restored.

YLI YK-168 [3/4] Operation of the control station

Содержание

Похожие устройства