Wacker Neuson BS 30, 6’’ 5216 [15/32] Safety instructions

SV00002GB

SAFETY INSTRUCTIONS

10. The operation of this vibrator may cause stones to bounce up. During operation no one except the op-

erator is to come near the machine.

11. The vibration rammer is to be guided in such a way that the operator is not squeezed between the vibra-

tor and solid objects. Special care is required when working on uneven ground or when compacting

coarse material. Make sure to stand firmly when operating the machine under such conditions.

12. Vibration rammers have to be used such that their stability is guaranteed.

13. When working near the edges of breaks, pits slopes, trenches and platforms, vibration rammers are to

be operated such that there is no danger of their turning over or falling in.

Safety checks

1. Vibration rammers may only be operated with all safety devices installed.

2. Before starting operation, the operator has to check that all control and safety devices function properly.

3. In case of defects of the safety devices or other defects reducing the operational safety of the vibration

rammer, the supervisor has to be informed immediately.

4. In case of defects jeopardizing the operational safety of the vibrator, the machine has to be stopped im-

mediately.

Maintenance

1. Only use original spare parts. Modifications to this machine including the adjustment of the maximum

engine speed set by the manufacturer are subject to the express approval of WACKER. In case of non-

observance all liabilities shall be refused.

2. Stop engine and pull off spark plug cap (if cluded )before carrying out maintenance jobs to avoid unin-

tentional starting of the eingine. Deviations from this are only allowed if the maintenance job requires a

running engine.

3. As soon as maintenance and repair jobs have been completed all safety devices have to be reinstalled

properly.

Transport

1. During transport, loading and unloading of vibration rammers by means of lifing devices, appropriate

slinging means or hooks have to be used on the lifting points provided for this purpose on the vibration

rammer.

2. The load-carrying capacity of the loading ramps has to be sufficient and the ramps have to be secure

such that they cannot turn over. Make sure that no one be endangered by machines turning over or slip-

ping or by moving machine parts.

3. When being transported on vehicles, precautions have to be taken that vibration rammers do not slip or

turn over.

Maintenance checks

According to the conditions and frequency of use, vibration rammers have to be checked for safe operation at

least once a year by skilled technicians, such as those found at WACKER-service centers and have to be re-

paired if necessary.

Please also observe the corresponding rules and regulations valid in your country.