Brother PJ-622 — решение проблем с перегревом и ошибками принтера [49/61]

Reference

Head or motor is cooling down The thermal head or motor is too hot.

Head:

If the thermal head becomes too hot, it may produce imaging

on the paper in areas not intended to be printed. This condition

is normal when printing documents with a great deal of “black”

content.

The printer will stop and resume printing after the print head

has cooled down.

To avoid or delay the onset of this condition, print using a lighter

density setting, reduce the amount of black space being printed

(for example, remove background shading and colours in

graphs and presentation documents), and make sure that the

printer has adequate ventilation and is not located in an

enclosed space.

Motor:

Do not use the printer continuously. If the printer is used

continuously, the motor will become too hot. In this case, the

printer will stop and resume printing after the motor has cooled

down.

Note

This condition may occur more often when the printer is

used at high altitude (more than 3,048 m (10,000 feet)) due

to a lower air density available to cool the printer.

Data reception error Data is not being received properly, most likely because of a

poor IrDA connection.

Reposition the printer and/or IrDA port on the computer and try

again.

Printer is in boot mode The AC adapter was unplugged while the firmware was being

updated, and the printer started up in boot mode the next time

it was started.

Contact your reseller or Brother Customer Service for

assistance.

Problem Solution