Pilotage Higlander 1:10 (RC7993) [12/34] Transmitter settings and setup

www.pilotage-rc.com

Transmitter Settings and Setup

The Pilotage Highlander is equipped with a three channel micro processer controlled Tx. This Tx allows one to ﬂuidly and accu-

rately change the settings of your model to match the performance needed to successfully challenge various obstacles that your

model will encounter. A solid understanding of the Tx settings are important to attain the best performance from the model.

This Tx likewise allows you to store up to 10 unique model settings.

The settings are accessible through the LCD menu which: reverses channels, sets channel end points, and sets dual rate control

throws.

When you turn on your Tx, note the number displayed on the upper left hand corner of the display. This number indicates the

memory slot that has been accessed and what saved settings are currently in use. In the lower left corner the Tx power voltage is

displayed. On the right side of the LCD the illustration references the steering regime your Highlander is currently using.

In order to move from one point of the menu to another use the “SEL” button. The Tx will emit a beep and the power LED will

ﬂash conﬁrming the registry of the button being pushed. To change the value selected ﬁelds use buttons DT1 or DT2.

When setting every point in the menu, the values of channel 1 (steering) will ﬁrst be adjusted, and then channel 2 (throttle). The

number of the channel being programmed is visible in the upper left corner of the display.

ATTENTION! If you do not make any adjustments to the Tx settings for 5 seconds following the change of the last parameter, the

Tx automatically reverts to the start up display.

NO. 1

10.4

DISPLAY

no.1

10.4

DISPLAY

ch 1

LCD Menu

Number of Model Memory Slot

Battery Voltage

Channel Number

Steering Regime