MikroTik RB951Ui-2nD [3/4] Federal communication commission interference statement fcc id tv7rb951ui 2nd

Federal Communication Commission Interference

Statement (FCC ID: TV7RB951Ui-2ND)

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the interference by one

of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

This device and its antenna must not be co-located or operation in conjunction with any other

antenna or transmitter.

IMPORTANT: Exposure to Radio Frequency Radiation.

13 cm minimum distance has to be maintained between the antenna and user. Under such

configuration, the FCC radiation exposure limits set forth for an population/uncontrolled environment

can be satisfied.

Antenna Installation. WARNING: It is installer's responsibility to ensure that when using the

authorized antennas in the United States (or where FCC rules apply); only those antennas certified

with the product are used. The use of any antenna other than those certified with the product is

expressly forbidden in accordance to FCC rules CFR47 part 15.204. The installer should configure the

output power level of antennas, according to country regulations and per antenna type. Professional

installation is required of equipment with connectors to ensure compliance with health and safety

issues.

Industry Canada (IC:7442A-9412ND)

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to

the following two conditions: (1) this device may not cause interference, and (2) this device must

accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio

exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit

pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

See www.routerboard.com for more information. Contact support@mikrotik.com 27-Apr-15