Faber JOLIE ACT WH A80 [6/128] Controls

Faber JOLIE ACT WH A80 [6/128] Controls
6
Controls






   
Button
Led
Function
L
- Turns the lights on/off at maximum strength.
All the LEDs ash twice – “Active
Noise” System Enabled.
AlltheLEDsashonceonly–“Active
Noise” System Disabled.
Press and hold the button for approximately 2
seconds to Disable / Enable the electronic “Active
Noise” system.
T1
Fixed Turns the motor on/off at speed one.
Flashing Press and hold the button for approximately 2 seconds
to Enable / Disable the Delay, automatic delayed
shut-down of the Motor and Lighting System after 30’.
T2
Fixed Turns the Motor on at speed two.
- Press and hold the button for approximately 2
seconds, with all the other loads off (Motor+Lights)
to activate calibration of the “Active Noise” system
(lasts 1.5 minutes).
T3
Fixed Turns the Motor on at speed three.
- Press and hold the button for approximately 2 sec-
onds, with all the loads turned off (Motor and Lights),
toperformareset.TheLEDS1ashesthreetimes.
T4 Fixed Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes. At the end
of this time, the system returns automatically to the
speed that was set before. If it is activated with the
motor turned off, it will switch to OFF at the end
of the time.
The LED ashes twice. - Enabled.
The LED ashes once - Disabled.
Press and hold for 2 seconds to Enable / Disable
the Remote control.
S1 Fixed Signals the Metal Grease Filter saturation alarm,
indicating that it is necessary to wash the lters.
The alarm is triggered after the Hood has been in
operation for 100 working hours.
Lighting
For replacement contact technical support
(“To purchase contact technical support”).

Содержание

Скачать