Faber INFINITY ACT WH A80 [6/128] Controls

Faber INFINITY ACT WH A80 [6/128] Controls
6
Controls
Button Function Led
A
Turns the Motor off. The Leds indicating the Speed of the motor turn off.
Enables / Disables Keyboard Lock mode if pressed and held for
5 seconds.
All the Leds light up in cycle.
B
Activates speed one. The Leds indicating Speed one and Motor Off turn on.
Press and hold for approximately 5 seconds, with all the other
loads off (Motor+Lights) to Activate calibration of the “Active Noise”
system (lasts 3 minuts).
Displaying an animation.
C
Activates speed two. The Leds indicating Speed two and Motor Off turn on.
D
Activates speed three. The Leds indicating Speed three and Motor Off turn on.
Press and hold the button for 5 seconds to Disable / Enable the
electronic “Active Noise” system.
Displaying light-up of certain symbols – “Active Noise”
system Deactivated
Displaying all symbols switched off – “Active Noise”
system Activated
E
Activates Intensive speed. This speed is timed to run for 6 min-
utes. At the end of this time the system will automatically return to
the speed set before.
It is disabled by pressing the Button or turning the Motor off.
Flashes once a second.
F
Starts the 24H function, in which the motor starts at a speed that
allows suction of 100 m3/h for 10 minutes per hour. This mode
cannot be activated if Intensive or Delay modes are active.
To turn it off, press the button again.
The Leds indicating 24H speed and Motor Off turn on.
When the lters alarm is triggered, the alarm can be reset by
pressing and holding this button for approximately 5 seconds.
These indications are only visible when the motor is turned off.
When the procedure terminates, the indication shown
previously turns off:
24H Flashing
Indicates the need to wash the metal grease lters.The
alarm is triggered after the Hood has been in operation
for 100 working hours.
G
Activates Delay mode, causing automatic shutdown of the Motor
and the Lighting system with a 30’ delay.
It is disabled by pressing the button or turning the motor off.
The Delay LED lights up.
Pressing and holding the button for 5 seconds enables the remote
control
Pressing and holding the button for 5 seconds disables the remote
control
ButtonALedashestwice.
ButtonALedashesonce.
H
Press briey to turn the lighting system on and offatmaximum
intensity.
The Lighting Led lights up.
Press and hold the button for 2 seconds to turn the Courtesy
Lights On (if provided).
Lighting
For replacement contact technical
support. (“To purchase contact
technical support”).

Содержание

Похожие устройства

Скачать