Gold Medal Breeze w/Lock n Go [3/24] Electrical requirements

The Breeze

3 Models: 3030, 3030SR, 3030EX, 3040 and 3040SR

Installation Instructions

Inspection of Shipment:

After unpacking, check thoroughly for any damage which may have occurred in transit.

Claims should be filed immediately with the transportation company. The warranty

does not cover damage that occurs in transit or damage caused by abuse or

consequential damage due to the operation of this machine, since it is beyond our control.

Your Floss Machine warranty is described on the back page of this manual. This does

NOT cover the motor bearings, since they can be damaged by the operator.

Electrical Requirements:

The following power supply must be provided:

Model No. 3030, 3030SR, 3040 and 3040SR: 120 VAC, 60 Hz, 15 Amps

Model No. 3030EX: 240 VAC, 50 Hz, 15 amps

Your electrician must furnish sufficient current for proper machine operation. We

recommend this floss machine be on a dedicated and circuit protected line. Failure to wire

properly will void the warranty and can result in damage to the heat elements, motor and

etc.

It is Gold Medal Products Company’s recommendation that this machine be plugged directly

into a wall outlet. The use of extension cords is not recommended due to safety concerns

and the floss machine’s performance may be sacrificed/reduced.

Before You Plug in Machine

Remove all padding and restraints.

Turn the two shipping knobs located around the motor mount casting counter-clockwise.

This will allow the motor mount casting to “float” freely on the springs. Note: This step

Is not necessary for the 3040SR.