Gold Medal Breeze w/Lock n Go [5/24] Heat control setting test

The Breeze

5 Models: 3030, 3030SR, 3030EX, 3040 and 3040SR

Heat Control Setting Test

1. Follow the guidelines described on page 3 for supplying power to machine.

2. With main switch still OFF, fill floss head. Always fill it 90% full with sugar. This 90% level

is necessary to obtain a balanced condition in the floss head. DO NOT OVERFILL!

Excessive vibration will occur if overfilled. Before turning the power on, manually turn the

head to balance out the sugar. This will eliminate excessive vibration of the head.

3. Turn MAIN SWITCH and HEAT SWITCH "ON." Note: Steps 4 – 8 do not apply to the 3040

or 3040SR.

4. Turn heat control knob clockwise to maximum setting to initiate the fastest possible warm

up.

5. The machine should start making floss in about 45 seconds. When the unit starts making

floss, you must reduce the heat setting. Turn the heat control knob counter clockwise to

eliminate smoking.

6. Once you find the ideal setting for the HEAT CONTROL, operate with the setting near this

position each time.

7. When finished making floss, run the floss head completely empty of sugar.

8. Turn the heat control dial to the maximum position, and allow the machine to run for

approximately 3-4 minutes. This will burn any excess sugar out of the head, and prevent

any excess carbon build- up.

9. Turn the heat switch “off” and allow the motor to run for 1-2 minutes to allow the floss head

to “cool down”.

10. Turn the motor switch off and allow the motor to come to a complete stop.