CRYSTAL VENUS 46 VITRINE (CURVED) гнутое стекло [4/7] Defrosting

10. DEFROSTING

If ice appears in the freezers walls, the freezer’s efficiency will be possibly minimized, so it is recommended

to “defrost” the appliance.

Defrosting procedure:

⎯ Unplug the appliance.

⎯ Remove the products from the freezer, rap them in paper, and refrigerate them. If it is difficult to refrigerate

them, put them in a carton box and keep them cold.

⎯ Leave the freezer’s glass or glasses open.

⎯ Scrap the walls covered with frost using a special plastic scraper.

⎯ If you wish, place a plastic recipient at the rear of the freezer, under the existent draining pipe, for the

concentration of the defrosting water.

⎯ Remove the plastic drainage tap located inside, at the bottom of the appliance and let the frost melt.

⎯ Make sure the frost in the interior of the appliance has melted and the bucket is clean and dry.

⎯ Replace the drainage tap at the bucket’s bottom.

⎯ Close the glass or the glasses and make sure they are in their proper position.

⎯ Insert the plug in the mains outlet.

⎯ Make sure the thermostat is on. If you wish to accelerate the freezer’s preparation, set the thermostat on

position 7.

⎯ Start-up the freezer with no load and keep the glass or the glasses closed for at least one hour.

⎯ Replace the products and reset the thermostat in the middle of the scale.

WARNING: do not try to accelerate the defrosting by using sharp metal tools or by placing heat

sources, e.g. heaters, inside the appliance.

11. MAINTENANCE (figure 3)

For the purpose of gleaning the freezer interior, DO NOT use sharp objects or chemicals in order to accelerate

the process of defrosting. Follow the instruction that is recommended by the manufacturer, i.e. the use of lather in

lukewarm water.

For proper operation of the appliance, the condenser must be free of dust. Clean the condenser at least

once in a month if your appliance is working outside or once in three months if is working inside your store,

as follows:

 Unplug the appliance.

 Remove the plastic grill from the appliance which is located at the left side.

 Clean the condenser by using a soft brush or a vacuum cleaner.

 Clean also the blades of the condenser ventilator by using piece of cloth.

 Replace the plastic grill back on the holding screws.

 Insert the plug and switch on the appliance.

Figure 3