Liebherr WKt 4551 [11/11] Shutting your appliance down

28. Insert hinge pin.

29. Push in hinge pin until groove in

the pin lines up with bore hole in

the hinge bracket.

Front view of top hinge bracket

30. Undo screw in hinge pin and

screw into bore hole in hinge

bracket.

31. Place the appliance in its final position at the place of instal-

lation.

Extend the adjustable foot at the bottom hinge bracket until

it rests on the floor and then make a further 90° turn.

32. Release cover on the inside and slide to

the outside.

Adjusting the lateral tilt of the door

If the door is at an angle, adjust the angle.

Front view of top hinge bracket

33. Turn cover downwards.

34. Undo screws and slide hinge bracket

to the right or left.

Tighten screws.

Re-fit cover following the instructions

above in reverse order.

Close door and check that it is aligned

with the side walls of the appliance.

Shutting your appliance down

If your appliance is to be shut down for any length of time, switch

it o and disconnect the plug or switch o or unscrew the fuse.

Clean the appliance and leave the door open in order to prevent

unpleasant smells.

The appliance complies with the relevant safety regulations and

EC Directives 2004/108/EC and 2006/95/EC.