Grohe Blue 33249DC0 [9/92] Environment and recycling

Grohe Blue 33249DC0 [9/92] Environment and recycling
6
Warning
Risk of damage:
Always disconnect the power supply before performing
maintenance work on the system. The plug-in connectors
can then be disconnected, see fold-out page II, Fig. [7].
Inspect and clean all components and replace if necessary.
I. Cartridge, see fold-out page III, Fig [15].
Assemble in reverse order. When installing the cartridge,
ensure that the seals are correctly seated. Replace screw
coupling and tighten.
II. Headpart, see fold-out page III, Fig. [16].
Assemble in reverse order. Note the installation position of the
stop.
III. Mousseur (64 374), see fold-out page I.
Assemble in reverse order.
Service
Note the Fault / Cause / Remedy table for information on
eliminating problems.
In the event of problems with the settings, please consult
a specialist installer or the GROHE Service Hotline via email
under TechnicalSupport-HQ@grohe.com.
Replacement parts
See fold-out page I (* = special accessories).
Care
For directions on the care of this fitting, please refer to the
accompanying Care Instructions.
Environment and recycling
Used filter cartridges can be returned to GROHE at the
address for the relevant country, at www.grohe.com. However,
the filter can also be disposed of hazard-free in domestic
waste.
Fault Cause Remedy
Water not flowing Water supply interrupted - Open shut-off valves
Filtered water not
flowing
Water supply interrupted - Establish water supply to fitting
Display in handle
does not illuminate,
E3 flashes in display
No connection between fitting
and control unit
Cable or connector faulty
- Attach connectors
- Contact Grohe Service
Handle flashes
orange, E8 flashes
in the display
No filter capacity - Change filter cartridge immediately
E6 or EE flashes
in the display
Conrol unit fault - Contact Grohe Service
Display in handle
illuminates red
No connection between fitting
and control unit
- Synchronise with one another, see section
Installation
Indicator lamps
do not flash/flash
continuously
Control not recognised - With mains plug connected, disconnect plug-in
connector, wait 30 seconds and reconnect
Display in handle
does not illuminate
or illuminates
continuously
No connection between fitting
and control unit
- Synchronise with one another, see section
Installation

Содержание

Похожие устройства

Скачать