Lainox REV101M Инструкция по технике безопасности (англ.) онлайн [5/11] 278239

Lainox REV101M Инструкция по технике безопасности (англ.) онлайн [5/11] 278239
ALI S.p.A.
Revision nr. 4
Dated 04/04/2015
ZARAM031
-
COMBICLEAN
Printed on 04/04/2015
Page n. 5/11
Threshold Limit Value.
Type
Country
TWA/8h
STEL/15min
mg/m3
ppm
mg/m3
ppm
TLV-ACGIH
2 (C)
OEL
IRL
2
WEL
UK
2
Health
-
Derived
no
-
effect level
-
DNEL / DMEL
Effects on
consumers.
Effects on
workers
Route of exposure
Acute local
Acute systemic
Chronic local
Chronic
systemic
Acute local
Acute
systemic
Chronic local
Chronic
systemic
Inhalation.
1 mg/m3
VND
1 mg/m3
VND
Legend:
(C) = CEILING ; INHAL = Inhalable Fraction ; RESP = Respirable Fraction ; THORA = Thoracic Fraction.
VND = hazard identified but no DNEL/PNEC available ; NEA = no exposure expected ; NPI = no hazard identified.
8.2.
Exposure controls.
As the use of adequate technical equipment must always take priority over personal protective equipment, make sure that the workplace is well aired
through effective local aspiration.
When choosing personal protective equipment, ask your chemical substance supplier for advice.
Personal protective equipment must be CE marked, showing that it complies with applicable standards.
Provide an emergency shower with face and eye wash station.
HAND PROTECTION
Protect hands with category III work gloves (see standard EN 374).
The following should be considered when choosing work glove material: compatibility, degradation, failure time and permeability.
The work gloves' resistance to chemical agents should be checked before use, as it can be unpredictable. The gloves' wear time depends on the duration
and type of use.
Suitable gloves for protection:
Material: PVC, butyl rubber, neoprene lined with natural rubber
Penetration time: > 480 minutes
Protection level: > 6
SKIN PROTECTION
Wear category III professional long-sleeved overalls and safety footwear (see Directive 89/686/EEC and standard EN ISO 20344). Wash body with soap
and water after removing protective clothing.
EYE PROTECTION
Wear a hood visor or protective visor combined with airtight goggles (see standard EN 166).
RESPIRATORY PROTECTION
If the threshold value (e.g. TLV-TWA) is exceeded for the substance or one of the substances present in the product, use a mask with a type P2 filter (see
standard EN 14387). In the presence of gases or vapours of various kinds and/or gases or vapours containing particulate (aerosol sprays, fumes, mists,
etc.) combined filters are required.
Respiratory protection devices must be used if the technical measures adopted are not suitable for restricting the worker's exposure to the threshold values
considered. The protection provided by masks is in any case limited.
If the substance considered is odourless or its olfactory threshold is higher than the corresponding TLV-TWA and in the case of an emergency, wear open-
circuit compressed air breathing apparatus (in compliance with standard EN 137) or external air-intake breathing apparatus (in compliance with standard
EN 138). For a correct choice of respiratory protection device, see standard EN 529.
ENVIRONMENTAL EXPOSURE CONTROLS.
The emissions generated by manufacturing processes, including those generated by ventilation equipment, should be checked to ensure compliance with
environmental standards.
SECTION 9. Physical and chemical properties.
LA67913220