![Vitamix Mix'n Machine Advance (VM025021-929) [11/14] Motor protection](/img/pdf.png)
Vitamix Mix'n Machine Advance (VM025021-929) [11/14] Motor protection
![Vitamix Mix'n Machine (VM025003-355) [11/14] Motor protection](/views2/1340057/page11/bgb.png)
TROUBLESHOOTING
20
21
Problems:
• Machine will not run
• Machine will not run when START
Actuator or ON/OFF power switch
is activated
Possible Actions:
a. Double-check to make sure power
cord is firmly plugged into power outlet
and that you have power to the outlet.
b. Check ON/OFF power switch to make
sure the switch is in the ON position.
c. Check to make sure switches are clean
and moving freely.
d. Check the reset breaker to see if it has
tripped. See page 21.
• Machine is running irregularly
• Setting selected starts
the wrong program
a. Reset the machine to its original factory
settings or reprogram with a custom
programming chip. See page 11.
b. Try plugging machine into a new outlet.
Problem:
• Loose or misaligned shaft
• Vibration noise
Possible Actions:
a. Unplug the machine.
b. Make sure the shaft extension is threaded tight onto the motor shaft with the slinger centered
and square.
c. To tighten a loose shaft, remove the cap and hold the motor shaft with a screwdriver in the slot
on the top end. Turn the agitator with your hand until tight. If tools must be used to hold the
shaft extension, be sure to protect it from being scratched as that would reduce its cleanability.
d. If the shaft is still misaligned, rotate the shaft by hand while holding a marking pen close
to the lower end. The first spot to touch and leave a mark is the side of the shaft most out
of alignment. Lay the machine on its back (remove the plastic agitator to avoid breakage)
and gently tap the marked side of the shaft with a rubber mallet. Repeat the process until
the marking pen leaves a mark most of the way around the shaft and the unit runs smooth.
Regulate your mallet taps to move the shaft towards the center without overshooting.
If you cannot fix your machine, call Vitamix Technical Support at (800) 866.5235.
If outside the United States and Canada, contact your local Vitamix Distributor
or telephone the Vitamix International Division at +1 (440) 782.2450 or email
international@vitamix.com for a distributor in your country.
MOTOR PROTECTION
FIGURE 1
The Mix’n Machine is equipped with a reset breaker
mounted on the motor enclosure. See Figures 1 and
2. Should the motor be kept from turning (locked
rotor) or otherwise be overloaded, the breaker will
trip. If this occurs, make sure the motor is free to
rotate and wait a short period for it to cool down
before pushing the reset breaker and restarting the
motor. Never remove or bypass the reset breaker.
Countertop Machine (Side View)
FIGURE 2
Wallmount Machine (Front View)
Reset Breaker
Reset Breaker
Содержание
- All models 1
- Mix n machine 1
- Read and save these instructions 1
- Use and care manual 1
- Important notes 2
- Important safeguards 2
- Save these safety instructions 2
- Warnings 2
- Control panel 3
- Important notes 3
- Mix n machine advance programmable model 3
- Mix n machine advance timer model 3
- Control panel 4
- Important notes 4
- Mix n machine advance variable speed model 4
- Mix n machine standard model 4
- General instructions 5
- Mix n machine blending procedures 5
- Programmable model 5
- General instructions 6
- Important notes 6
- Programming 6
- Programming with a custom chip 6
- Resetting the pre set programs to the original factory settings 6
- Agitators 7
- Caution 7
- Important notes 7
- Splash guard 7
- Caring for your machine 8
- Housing 8
- Important notes 8
- Permanent agitators 8
- Removable reusable agitator 8
- Kits sold separately 9
- Mix n machine advance and mix n machine standard countertop models 9
- Parts list 9
- Kits sold separately 10
- Mix n machine standard wall mount model 10
- Parts list 10
- If you cannot fix your machine call vitamix technical support at 800 866 235 if outside the united states and canada contact your local vitamix distributor or telephone the vitamix international division at 1 440 782 450 or email international vitamix com for a distributor in your country 11
- Motor protection 11
- Possible actions 11
- Problem 11
- Problems 11
- The mix n machine is equipped with a reset breaker mounted on the motor enclosure see figures 1 and 2 should the motor be kept from turning locked rotor or otherwise be overloaded the breaker will trip if this occurs make sure the motor is free to rotate and wait a short period for it to cool down before pushing the reset breaker and restarting the motor never remove or bypass the reset breaker 11
- Troubleshooting 11
- Limited warrant 12
- Unless otherwise covered by contract 12
- Warranty 12
- What causes the warranty to be void 12
- What is covered under warranty 12
- What is not covered under warranty coverage exclusions 12
- When do the warranties apply coverage conditions 12
- How to obtain warranty coverage and repair 13
- How to ship the equipment for service 13
- Warranty 13
- Corporation commercial division 14
- Dimensions 14
- Motor speed and power requirements 14
- Products visit vitamix com 14
- Specifications 14
- To see the complete line of vitami 14
- Vita mi 14
- When applicable 14
Похожие устройства
- ATESY СР-Л-1-1200.600-02 Инструкция по эксплуатации
- ATESY СР-Л-1-1200.600-02 Презентация нейтрального оборудования ATESY 2-го поколения
- ATESY СР-Л-1-1200.600-02 Декларация о соответствии
- Abat ТМС-30НН-МЦ Инструкция по эксплуатации
- Abat ТМС-30НН-МЦ Паспорт на Abat ТМС-30НН-МЦ
- ATESY СКТС-Б-900-02 Инструкция по эксплуатации
- ATESY СКТС-Б-900-02 Презентация нейтрального оборудования ATESY 2-го поколения
- ATESY СКТС-Б-900-02 Декларация о соответствии ЕЭС
- ATESY СК-П-1500.800-02 Инструкция по эксплуатации
- ATESY СК-П-1500.800-02 Презентация нейтрального оборудования ATESY 2-го поколения
- ATESY СК-П-1500.800-02 Декларация о соответствии
- ATESY СР-С-2-700.700-02 Инструкция по эксплуатации
- ATESY СР-С-2-700.700-02 Презентация нейтрального оборудования ATESY 2-го поколения
- ATESY СР-С-2-700.700-02 Декларация о соответствии
- ATESY СКТ-С-600-02-Н Инструкция по эксплуатации
- ATESY СКТ-С-600-02-Н Презентация нейтрального оборудования ATESY 2-го поколения
- ATESY СКТ-С-600-02-Н Декларация о соответствии ЕЭС
- ATESY Ривьера 700 мм Инструкция по эксплуатации
- ATESY ШО-1 оцинк. сталь Инструкция по эксплуатации
- ATESY ШО-1 оцинк. сталь Декларация о соответствии ЕЭС