Commax CLS-10R [9/14] Assembly method

－9－

2) Assembly Method

1) Several layers assembled into one line

① Release the screw at the top of CLS-10 to open the upper cover.

② Connect the 6P connector coming from CLS-10 to CN 101 6P WAFER of

CLS-10T (L), place CLS-10T (L) on CLS-10 and fix them with screws.

③ Connect the 6P connector of CLS-10T (L) to CN 101 6P WAFER of

CLS-10T (R), place CLS-10T (R) on CLS-10T(L)

and fix them with screws.

④ For expansion, repeat Steps 2 and 3 to assemble CLS-10T (L) and CLS-

10T (R).

⑤ Close the cover when assembly of the last layer is completed.

2) Several layer assembled into two lines

① Release the screws at the top and bottom of CLS-10 to open the upper

and lower covers.

② Open the upper and lower covers of CLS-10W.

③ Position CLS-10 and CLS-10W side by side and fix the three points on

the surfaces facing each other with the clips included in the accessories.

④ Cut off the ventilating hole on the lateral surface of CLS-10T (R) to be

placed on CLS-10W of CLS-10 for expansion.

⑤ Insert the 6P connector to 6P WAFER (CN208) of CLS-10 (K) of CLS-

10 and connect it to CLS-10T (R) to be expanded using the ventilation

hole cut off.

⑥ Connect the 6P connector of CLS-10 to CN 101 WAFER of CLS-10T

(R), place CLS-10T (R) on CLS-10 W and fix them with screws.

⑦ For expansion, repeat Steps 2 and 3 of“(1) Several layers assembled into

one line”for the two lines.

⑧ When assembly of the last layer is completed, fix the surfaces facing each

other of the last layer with the clips included in the accessories and close

the upper and lower covers.

3) Several layers assembled into several lines

For expansion in several layers assembled into several lines, repeat (1)

Several layers assembled into a line and (2) Several layer assembled into

two lines.

www.safemag.ru