Vitek VT-3536 [16/32] Qxd 30 8 004 14 48 page 15
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Vitek VT-3536 [16/32] Qxd 30 8 004 14 48 page 15

Vitek VT-3536 [16/32] Qxd 30 8 004 14 48 page 15
TROUBLESHOOTING
15
PROBLEM
The temperature and
humidity data on the
remote transmitter does
not match the data dis-
played on the receiver.
The temperature and
humidity data on the
remote transmitter does
not match the data dis-
played on the receiver.
The remote (outdoor)
readout on the receiver is
blinking.
The remote (outdoor)
readout on the receiver is
blinking. The receiver will
not detect or receive the
temperature and humidity
data from the remote
transmitter, even after the
Manual Learn Function has
been executed.
SOLUTION
This may occur when you move the remote transmitter
from one environment to another. For example, when you
bring the transmitter from inside the warm house out to
the cold exterior. In such a case, there will be a big
change in temperature. The transmitter will record this
change in temperature much quicker than it is able to
transmit the data to the receiver (which is done once
every minute). Therefore, you will temporarily get a differ-
ence in reading between the remote transmitter and
receiver.
The solution is to allow the remote transmitter some time
to sit in its new location to reach equilibrium. This may
take several minutes. Once the data is stable, the data
displayed on the remote transmitter should match that
displayed on the receiver.
This may also be the result of a temporary loss of recep-
tion due to interfering sources. Normal reception should
resume once the interference ends. Refer to the WIRE-
LESS TRANSMISSION section.
Re-synchronize the remote transmitter and receiver by
pressing and holding CHN on the receiver for 3 seconds
until a beep is heard. The temperature and humidity data
from the remote transmitter will display on the receiver
within 3 minutes. Refer to the WIRELESS TRANSMISSION
(Manual Learn Function) section.
Ensure the remote transmitter is away from any possible
source of interference and electrical disturbances. You
may try to reposition the remote transmitter in a different
location and/or closer to the receiver. The remote trans-
mitter does have a maximum range of 40 metres, but any
walls or windows the signal has to pass through will
reduce the distance. Due to the nature of the batteries,
extreme cold temperatures may also affect the transmis-
sion range.
Refer to the WIRELESS TRANSMISSION section and
repeat the Manual Learn Function with the remote
transmitter in a new location.
ENGLISH
3536.qxd 30.08.2004 14:48 Page 15

Содержание

Похожие устройства

Скачать