Home
Главная
FSP
Proline 3/3 10K
Инструкция по эксплуатации Страница: 15

FSP Proline 3/3 10K — информация о батарее и управление источником бесперебойного питания [15/36]

FSP Proline 3/3 15K [15/36] 4 single ups operation

Battery information

Indicates the Battery capacity by 0-25%, 26-50%, 51-75%, and 76-100%.

Indicates the battery is not connected.

Indicates low battery level and low battery voltage.

Input & Battery voltage information

Indicates the input voltage or frequency or battery voltage.

Vac: Input voltage, Vdc: battery voltage, Hz: input frequency

3-3. Audible Alarm

Description

Buzzer status

Muted

UPS status

Bypass mode

Beeping once every 2 minutes

Yes

Battery mode

Beeping once every 4 seconds

Fault mode

Beeping continuously

Warning

Overload

Beeping twice every second

Others

Beeping once every second

Fault

All

Beeping continuously

Yes

3-4. Single UPS Operation

1. Turn on the UPS with utility power supply (in AC mode)

1) After power supply is connected correctly, set the breaker of the battery pack at “ON” position (the

step only available for long-run model). Then set the line input breaker at “ON” position(for dual

input unit, also set the bypass input breaker at “ON”). At this time the fan is running and the UPS

enter to power on mode for initialization, several seconds later, UPS operates in Bypass mode and

supplies power to the loads via the bypass.

NOTE: When UPS is in Bypass mode, the output voltage will directly power from utility after you

switch on the input breaker. In Bypass mode, the load is not protected by UPS. To protect your

precious devices, you should turn on the UPS. Refer to next step.

2) Press and hold the “ON” button for 0.5s to turn on the UPS and the buzzer will beep once.

3) A few seconds later, the UPS will enter to AC mode. If the utility power is abnormal, the UPS will

operate in Battery mode without interruption.

NOTE: When the UPS is running out battery, it will shut down automatically at Battery mode. When the

utility power is restored, the UPS will auto restart in AC mode.

2. Turn on the UPS without utility power supply (in Battery mode)

1) Make sure that the breaker of the battery pack is at “ON” position (only for long-run model).

2) Press the “ON” button to set up the power supply for the UPS, UPS will enter to power on mode.

After initialization UPS will enter to No Output mode, then Press and hold the “ON” button for 0.5s

to turn on the UPS, and the buzzer will beep once.

3) A few seconds later, the UPS will be turned on and enter to Battery mode.

FSP Proline 3/3 10K — информация о батарее и управление источником бесперебойного питания [15/36]

Содержание

Похожие устройства