Clarion VMA573 [27/33] Wiring the monitor

Wiring the monitor

3. Create passage holes for the power and video cables.

When drilling through metal or plastic, use grommets to protect the cables

from sharp edges that could penetrate the insulation and cause a short

circuit and device failure.

4. Connect the ground lead (black) securely to a clean metal plate on the

vehicle.

Use sand paper to remove any paint from the surface where you attach

the ground terminal.

5. Reconnect the negative (-) lead to the battery.

Monitor connections

IR connector polarity :

PLASTIC COVER

This 3.5Φ IR Jack has plastic cover to prevent short, to remove the plastic

cover, please do not pull it out directly, please rotate the plastic cover and put it

out slowly.

Some non-Clarion automotive DVD and VCP source

units use a similar connector for an external IR receiver,

but use different pin polarity than the Clarion uses.

Connecting non-Clarion source equipment to this

connector could cause equipment damage not covered

by the warranty!

CAUTION !