Trust 71170 ZIGBEE ZPIR-8000 [3/27] En zpir 8000 motion sensor zpir 8000 motion sensor en

Trust 71170 ZIGBEE ZPIR-8000 [3/27] En zpir 8000 motion sensor zpir 8000 motion sensor en
EN ZPIR-8000 MOTION SENSOR ZPIR-8000 MOTION SENSOR EN
54
COMPATIBILITY
The sensor works with the Z1 ZigBee Bridge and the ICS-2000.
1. (RE)PLACE THE BATTERIES
A
Remove the battery cover from the sensor.
B
Place 2x AAA batteries (not included) in the sensor. Note the positive and
negative polarity in the compartment. Close the battery cover.
2. INDICATORS
The sensor contains a LED indicator (This is not a button) to show the status
of the sensor. Please see below the meaning of the dierent LED indications.
LED FUNCTION TABLE
Connection mode LED will flash once per second for
approximately 1 min. (After 1 min
the LED will stop flashing)
Connected successfully LED will stop flashing (The App will
also indicate when the connection
is successful)
Sensor reset LED will flash fast (for 2 seconds)
Sensor triggered (When motion
is detected)
LED will flash once
3. DOWNLOAD APP
To connect the sensor with a Z1
ZigBee bridge or ICS-2000, first get
the App by scanning the QR code or
go to trust.com/zigbee and install it.
4. CONNECT SENSOR
A
In the App, select a room,
press the + button and follow
instructions.
For manual set up of push-
notifications go to the rules tab,
press the + button and select
notification wizard.
5. MOUNT THE SENSOR
A
Mount the arm of the sensor on a
flat surface and secure it with the
included screws.
B
1. Place the sensor on the
mounting arm.
2. Secure the sensor by pulling it
down on the mounting arm.
RESET SENSOR AND
ACTIVATE CONNECT MODE
Warning: This step will remove
the sensor from the Z1 ZigBee Bridge
or the ICS-2000. To reset the sensor
press the button in the hole at the
side of the sensor for approximately
5 sec with the included pin. The LED
will flash fast to confirm the reset.
Activate connect mode: After
resetting the sensor you can activate
the connect mode by pressing the
button for approx. 1 sec. The LED
will flash for 1 minute to indicate the
connection mode.
The wireless range increases when
you add more ZigBee products (me-
shing). To learn more about meshing
go to trust.com/zigbee

Содержание

Похожие устройства

Скачать