Atlantic INGENIO 50 [10/36] Maintenance

MAINTENANCE

CAUTION: Before removing the plastic cover, make sure the power is turned off to avoid

any risk of injury or electric shock.

1. USER MAINTENANCE

Operates once a month the discharge of the safety valve to prevent scaling deposit and

verify that the safety device is not blocked. If this is not done, damage may be caused and the

guarantee invalidated. For an installation with a booster pump; before starting up, after a long

period of disuse, turn the rotor following the advice in the manufacturer’s instructions.

2. MAINTENANCE BY A QUALIFIED PERSON

- Scaling: Remove the scale sludge. Do not scrape or hammer the lime scale deposited on the

casing, as this may damage the lining.

- Magnesium anode: change the magnesium anode every 2 years or when its diameter is lower

than 10 mm.

- Heating element: the replacement of a sheathed heating element involves draining of the water

heater and replacement of the flange gasket. Reassemble the heating element, reasonably tight

nuts (cross tightening), check that there is no leakage after the first heating-up, tighten again if

necessary

- Drain: Turn off power and cold water supply. Open hot water taps and drain valve of the safety

device.

Spare parts list: thermostat, flange gasket, heating element, heating light indicator, magnesium

anode, connection wires, electric switch. The guarantee requires genuine manufacturer’s parts

to be used.

Advice to the user

 When the water has a TH > 20°f, it is recommended that this be treated. When a softener

is used, the water hardness must remain above 15°f.

 In case of prolonged absence, especially in winter, drain your appliance following the

procedure.