MONTOLIT TORNADO 970T [20/28] English

ENGLISH

• Be sure the motor is in pulled down position (2).

• Check the laser calibration.

• Position the tile pressed against the work-table fence and adjust the universal guide to x it

in this position (3).

• Lift the ON/OFF switch to turn the saw on.

• The correct position of the hands is shown in gure 5.

• Proceed to cutting by slowly positioning the diamond disk against the material to be cut,

advancing with a speed proportional to the thickness and hardness of the material.

• Slow down the advancement speed near the end of cutting.

• After having completed the cut, turn o the engine through the switch.

• Whenever the end of the tile breaks (the last centimeter), sharpen the diamond disk.

45°

2 3

4 5