MONTOLIT TORNADO 970T [21/28] English

ENGLISH

• Check the laser calibration.

• Turn the motor unit and be sure the motor is in pulled down position.

• Position the tile pressed against the work-table fence and adjust the universal guide to x it

in this position.

• Lift the ON/OFF switch to turn the saw on.

• The correct position of the hands is shown in gure 4.

• Proceed to cutting by slowly positioning the diamond disk against the material to be cut,

advancing with a reduced speed.

• After having completed the cut, turn o the engine through the switch.

• Gradually press down on the driving handle so that the disk enters the plate and emerges

from the opposite side.

• The correct position of the hands is shown in gure 4.

SQUARE AND

RECTANGULAR HOLES

2 4

Jolly

22,5° 45°