Ada GroundDrill-14 без шнека [9/34] Grounddrill 14

MEASUREMENT FOUNDATION

GroundDrill-14

INSTRUMENTS

1. Let engine warm for at least 1 min.

2. Press or release throttle lever to get desired rpms. If the engine reduce rpms on load, adjust the position of throttle lever.

Important! Do not work without workmate. Otherwise it can lead to the damages. Avoid running at high rpms for long periods. The

unit needs time for lubricant to get to all internal parts. Do not run the motor at high rpms without load.

THE SELECTION OF THE GEAR CASE ROTATION DIRECTION (for the model GD-14 Reverse)

The gear case of ADA GD-14 Reverse allows to change the rotation direction. Use the reverse function when drilling with auger bit of

big diameter from 300 mm and complicated grounds. Release gas handle when the auger bit is fully dipped into the earth. Then it is

necessary to stop drilling. Change the direction of rotation. Shift the handle for the reverse operation into the extreme position from the

engine. Press gas handle. At that slowly move the ground drill up. Use the reverse function for getting the auger bit out from the earth.

Never use the reverse function for drilling. Reverse handle must be in the extreme position towards the engine when drilling.

7. Stopping

1. Release throttle to idle speed.

2. Move main switch on/off to OFF.

Note: When storing for long periods, remove all fuel from the gas tank. Do not leave the gas tank at an angle. The pressure inside the

tank can cause the gas to spill out. The working parts of the engine can get very hot.

8. Daily maintenance

Make sure the engine is off before you begin any maintenance or repairs. To prevent accidental engine start disconnect spark plug cap.

Note: Check and adjust regularly the engine if you want to achieve high performance of it. Regularly maintenance extends engine life.

In the table below there is a maintenance schedule with regular service periods.