Airwell AQL 80 — основные рекомендации по техническому обслуживанию оборудования [39/63]
Превью страниц
Страница 39 /
63
![Airwell AQL 25 [39/63] Maintenance](/views2/1409371/page39/bg27.png)
Page 38
Maintenance
Check the temperature of the fluid
leaving the exchanger
Check any exchanger load loss
Check the electrical absorption
Check the suction temperature and
pressure
Check the delivery temperature and
pressure
Check the compressor oil level
Make sure there is no gas bubble in
the liquid line
Make sure the finned pack of the
external battery is clean
Check the operation of the oil
heater
Check the operation of the Remote
Control Unit
Check the operation of the high
pressure switch
Check the insulation of the
circulating refrigerant / fluid
exchanger
Make sure the screws of terminals
are firmly tight
Clean the external surfaces of the
unit with soapy water
Check the operation of the
differential pressure switch
Check the density of the antifreeze
mixture (glycol water) if this mixture
is used
Drain and clean the circulating
refrigerant / fluid exchangers
7 MAINTENANCE
While discharging the refrigerating
circuits, never release the refriger-
ant into the atmosphere. Use prop-
er recovery equipment for the dis-
charge. If the recovered refrigerant
can not be reused, it shall be re-
turned to the producer.
Never dispose of the compressor oil
in the atmosphere since it contains
dissolved refrigerant. If used, the oil
shall be returned to the producer.
The Safety Section of this manual shall be
carefully read before performing any
maintenance operation on the unit.
Unless otherwise specified, the maintenance opera-
tions here below can be performed by any mainte-
nance technician who has been specifically trained.
7.1 General Information
Itelco-Clima AQL/AQH units have been designed
for constant operation, provided that they are regu-
larly serviced and operated within the limits speci-
fied by this manual. Every unit shall be serviced ac-
cording to a User / Customer schedule and regularly
inspected by the personnel from an authorised Itelco-
Clima Service Centre.
It is the User’s responsibility to fulfil these mainte-
nance requirements and/or make an agreement
with an Itelco-Clima Service Centre so as to protect
the operation of the device.
If any damage or failure should occur as a result of
improper maintenance during the warranty period,
Itelco-Clima will not be liable for any cost required to
restore the original state of the device.
This section is only applicable for basic AQL/AQH
units. According to the circumstances, it might be
supplemented with additional instructions as a result
of any change which may be made to the unit or to
the use of the ancillary equipment.
7.2 Daily Maintenance
Maintenance checks shall be performed by a com-
petent person according to the schedule here
below.
Operations
Daily
Weekly
Monthly
Season start
Season end
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
••
•
However, it shall be noted that AQL/AQH units can
not be directly repaired by the User who shall refrain
from attempting to repair any failure which may be
discovered during daily maintenance. In case of
doubt, contact the Itelco-Clima Service Centre.
Scheduled Maintenance
Содержание
272- Installation and maintenance manual
- Aql aqh 20 130
- English
- Air cooled water chillers and air to water reverse cycle heat pumps
- Iom aqlh n gb
- English
- Preface
- Manufacturer information
- Warranty
- Safety
- English
- Manufacturer information
- Emergency stop
- Manufacturer information
- Safety labels
- English
- Material safety data
- Manufacturer information
- Page 6
- Refrigerant data
- English
- Page 7
- Manufacturer information
- Page 8
- Manufacturer information
- Lubricating oil data
- Product description
- General information
- English
- Accessories
- Product description
- Product description
- English
- Units aql 20 80
- Refrigeration circuits
- Product description
- Page 12
- Units aql 90 130
- Product description
- Page 13
- English
- Units aqh 20 80
- Product description
- Page 14
- Units aqh 90 130
- Product description
- Page 15
- English
- Handling
- Transportortion handling and stockage
- Transportation handling and storage
- Inspection
- Transportortion handling and stockage
- Storage
- English
- Installation
- Installation site
- Defrost water drainage only for aqh units
- Installation of spring shock absorbers
- Installation
- English
- Installation
- External water circuit
- Connect the water lines of the plants with the at tachments of the unit whose diameters and positions are shown by chapter 9
- Before filling the installation remove any impurity such as sand crushed stones and welding scales coating drops and any other material which might damage the evaporator
- When two or several units are connected in paral lel to balance the load losses of the various cir cuits it is recommended to execute a reverse re turn connection see the diagram below
- Water connections
- Version with a pump
- The water used to fill the circuit shall be treated in such as way that the ph will have the correct value
- The attachments at the water inlet and out let shall be connected in compliance with the instructions which can be found on the labels in the proximity of the attachments
- Page 21
- Legend s on off valves vg balancing valves
- It is advisable to flush with disposable water by passing the exchanger to avoid clogging
- Installation
- English
- Supplied material
- Shock absorbers
- Operating limits
- Installation
- Features
- Accumulation tank kit
- Installation
- English
- Storage kit 224 112 l for aql 40 50 aqh 40 dimensional data
- Storage kit 112 l for aql aqh 20 35 dimensional data
- Page 24
- Installation
- Storage kit 294 147 l for aql aqh 90 100 aqh 90 dimensional data
- Storage kit 294 147 l for aql 60 80 aqh 50 80 dimensional data
- Page 25
- Installation
- English
- Storage kit 294 147 l for aql aqh 110 130 aqh 100 130 dimensional data
- Page 26
- Installation
- Electrical connections
- Electrical supply features
- Installation
- English
- Electronic board
- Pump control relay
- Page 28
- Installation
- Electrical connections of the aql aqh 20 35 units with neutral
- Antifreeze resistance control relay
- Pump control relay
- Page 29
- Installation
- English
- Electronic board
- Electrical connections of the aql aqh 40 80 units with neutral
- Antifreeze resistance control relay
- Antifreeze resistance control relay
- Pump control relay
- Page 30
- Installation
- Electronic board
- Electrical connections of the aql aqh 40 80 units without neutral
- Mors 103 hydrokit mors 8 hydrokit
- Linea potenza 400 3 n 50 pe
- Vac disponib per accessori max 40va
- Interruttore remoto di marcia arresto
- Unita in allarme n o spst max 2 a 250vac
- Interblocco esterno consenso pompa esterna
- Sezionatore
- Installation
- English
- Selezione riscald raffredd
- Electronic board
- Selezione modalita notte o doppio setopoint
- Electrical connections of the aql aqh 90 130 units without neutral
- Scheda elettronica
- Comune
- Rele comando resistenza antigelo
- Caldo freddo
- Rele comando pompa
- Antifreeze resistance control relay
- Pump control relay
- Parzializzazione forzata della capacita frigorifera
- Page 31
- On off
- Morsettiera bordo macchina collegamenti utente
- Mors 14 hydrokit mors 8 hydrokit
- Preliminary checks
- Commissioning
- Starting
- Performance check
- English
- Delivery to the user
- Commissioning
- Electronic card control
- Aql aqh control
- English
- Dip switches
- Aql aqh control errata corrige
- Aql aqh control
- Sens menu sensors reading
- English
- Aql aqh control
- Alar and log menus
- Daily maintenance
- Maintenance
- General information
- Refrigerant charge
- Refrigerant air exchangers
- Maintenance
- Fans of the refrigerant air exchangers
- English
- Dryer filter
- Compressors
- Thermal expansion valves
- Sight glass
- Refrigerant circulating fluid exchanger
- Maintenance
- Probable cause remedy
- Page 41
- English
- Trouble shooting
- The following table will give a detailed list of unit faults and remedies contact an authorised itelco clima service centre for any other problem which can not be clearly ascribed to one of the cases listed in the table and or for any other need for technical assistance
- Trouble shooting
- Probable cause remedy
- Page 42
- Technical data
- Page 44
- Aql aqh 90 130 standard water pump available head
- Aql aqh 20 25 30 35 refrigerant water heat exchangers pressure drops
- 100 90
- Technical data
- Page 45
- English
- Aql aqh 90 130 refrigerant water heat exchangers pressure drops
- Aql aqh 40 80 refrigerant water heat exchangers pressure drops
- Air temperature c
- Working range in cooling mode working range in heating mode
- Working range
- Units aql aqh 20 130 r407c
- Technical data technical data technical data
- Page 46
- Leavig water temperature c leavig water temperature c
- Page 47
- Noise levels
- Models 20 25 30 35 40 50 60 70 80 90 100 110 120 130
- Model octave band central frequency hz
- Italiano
- High pressure transducer yes low pressure transducer yes
- High pressure switch yes
- Fans heat protection yes
- English
- Compressors heat protection yes
- Water flow switch yes
- Technical data
- Sound pressure levels lp a db a
- Sound pressure levels at 1 m distance according to iso 3744 sound levels applicable to all high discharge head units 90 130
- Sound power levels lw a db a
- Safety devices
- Units aql aqh 20 80
- Technical data technical data technical data
- Page 48
- General characteristics
- Units aql aqh 90 130
- Technical data technical data technical data
- Page 49
- English
- Page 50
- Electrical characteristics
- Units aql aqh 20 80
- Technical data technical data technical data
- Units aql aqh 90 130
- Technical data technical data technical data
- Page 51
- English
- Units aql aqh 20 130
- Technical data
- Page 52
- Dimensional data
- Units aql aqh 20 25 30 35
- Technical data
- Page 53
- English
- Technical data
- Page 54
- Units aql 40 50 and aqh 40
- Units aql 60 70 80 and aqh 50 60 70 80
- Technical data
- Page 55
- English
- Units aql aqh 90 100
- Top view
- Technical data
- Page 56
- Front view side view
- Units aql aqh 110 120 130
- Top view
- Technical data
- Page 57
- Front view side view
- English
- Technical data
- Space requirements
- The tables here below will list the wiring diagrams relevant for pack and non pack units with and without a neutral
- The table here below will list the spare parts which are recommended for each unit for two years
- The table here below will list the oils recommended for each model
- Spare parts errata corrige
- Spare parts
- Relevant wiring diagrams
- Recommended spare parts
- Page 60
- Oils recommended for compressors
- General information
- English
- Dismantling demolition and scrapping
- Wesper s a s
Похожие устройства
-
Airwell AQL 130Подробное техническое описание -
Airwell AQL 120Техническая спецификация -
Airwell AQL 110Официальные технические данные -
Airwell AQL 100Технический обзор -
Airwell AQL 90Технический паспорт устройства -
Airwell AQL 80Документ с характеристиками -
Airwell AQL 70Подробное техническое описание -
Airwell AQL 60Техническое описание -
Airwell AQL 50Технические характеристики -
Airwell AQL 40Datasheet -
Airwell AQL 130Инструкция по монтажу -
Airwell AQL 130Инструкция по эксплуатации
Узнайте, как правильно проводить техническое обслуживание и проверку оборудования для обеспечения его надежной работы. Следуйте рекомендациям по регулярным проверкам и уходу.