Beko WRE 6511 BWW [32/52] Removing packaging reinforcement

Содержание

2 2 Removing packaging reinforcement Tilt the machine backwards to remove the packaging reinforcement Remove the packaging reinforcement by pulling the ribbon 2 3 Removing the transportation locks WARNING Do not remove the transportation locks before taking out the packaging reinforcement WARNING Remove the transportation safety bolts before operating the washing machine Otherwise the product will be damaged 1 Loosen all the bolts with a suitable spanner until they rotate freely C 2 Remove transportation safety bolts by turning them gently 3 Attach the plastic covers supplied in the User Manual bag into the holes on the rear panel P Keep the transportation safety bolts in a safe place to reuse when the washing machine needs to be moved again in the future Never move the product without the transportation safety bolts properly fixed in place 2 4 Connecting water supply The water supply pressure required to run the product is between 1 to 10 bars 0 1 1 MPa It is necessary to have 10 80 liters of water flowing from the fully open tap in one minute to have your machine run smoothly Attach a pressure reducing valve if water pressure is higher If you are going to use the double water inlet product as a single cold water inlet unit you must install the supplied stopper to the hot water valve before operating the product Applies for the products supplied with a blind stopper group WARNING Models with a single water inlet should not be connected to the hot water tap In such a case the laundry will get damaged or the product will switch to protection mode and will not operate WARNING Do not use old or used water inlet hoses on the newproduct lt may cause stains on your laundry 1 Tighten all hose nuts by hand Never use a tool when tightening the nuts 2 Open the taps completely after making the hose connection to check for water leaks at the connection points If any leaks occur turn off the tap and remove the nut Retighten the nut carefully after checking the seal To prevent water leakagesand damages caused by them keep the taps closed when the machine is not in use 2 5 Connecting to the drain The end of the drain hose must be directly connected to the wastewater drain or to the washbasin WARNING Your house will be flooded if the hose comesout of its housing during water discharge Moreover there is risk of scalding due to high washing temperatures To prevent such situationsand to ensure smooth water intake and discharge of the machine fix the end of the discharge hose tightly so that it cannot come out 32 EN Washing Machine User s Manua