Kuppersberg GS 6020 [11/33] Filter assembly

Kuppersberg GS 6020 [11/33] Filter assembly
20 21
TECHNICAL PASSPORT ENGLISH ENGLISH TECHNICAL PASSPORT
Dishwasher Dishwasher
Hot dishes are sensitive to knocks.
The dishes should therefore be allowed
to cool down around 15 minutes before
removing from the appliance.
Open the dishwasher’s door,
leave it ajar and wait a few minutes
before removing the dishes. In this way
they will be cooler and the drying will
be improved.
Unloading the dishwasher
It is normal that the dishwasher is
wet inside.
Empty the lower basket rst and
then the upper one. This will avoid
water dripping from the upper basket
onto the dishes in the lower one.
7. MAINTENANCE AND
CLEANING
Filtering System
The lter is used to avoid the big
remnants and other sundries getting
inside he pump. The residue can
obstruct the fi lter in sometime.
The lter systemconsists of acoarse
lter, a fl at (Main fi lter) and a micro
Iter (fi ne fi lter).
1. Flat fi lter
Food and debris will be trapped by a
specialjet on the lowerspray arm.
2. Coarse fi lter
Big debris, suchas bone andglass
that couldclog the drain will betrapped
in thecoarse fi lter.
To remove an item caught in this
lter, gently squeeze the taps on the top
of this fi lter and lift it out.
3. Micro fi lter
This lter holdssoil and food residue
in thesump area and prevents itfrom
being redepositon the dishes during a
cycle.
Inspect thefi lters for
obstructionsevery time the dishwasher
has been used.
By unscrewing the coarse
lter, you can remove the lter system.
Remove any food remnants and clean
the fi ltersunder running water.
Step 1: contrarotate the Coarse
lter ,and then lift itup; Step 2: lift the
Flatfi Iter up
NOTE: If operate from step 1 to step
2, the fi lter system will be removed;
while operate from step 2 to step 1, the
lter system will be installed.
Filter assembly
For best performance and results,
the lter assembly must be cleaned. The
lter effi ciently removesfood particles
from the wash water, allowing it to
be recirculated during the cycle. For
this reason, itis a good idea to remove
the larger food particles trapped in
the lter after each wash cycle by
rinsingthe semicircular lter and cup
under running water. To remove the
lter assembly, pull on the cuphandle
in the upward direction. The entire
lter assembly should be cleaned once
a week. To cleanthe coarse lter and
the micro lter, use a cleaning brush.
Then, reassemble the lter parts as
shownin the fi gures above and reinsert
the entire assembly in the dishwasher,
positioning in its seat andpressing
downward. The dishwasher must never
be used without the lters. Improper
replacementof the fi lter may reduce the
performance level of the appliance and
damage dishes and utensils.
WARNING!
Never run the dishwasher without
the lters in place. When cleaning the
lters, don’t knock on them. Otherwise,
the lters could be contorted and the
performance of dishwasher could be
debased.
Cleaning the Spray Arms
It is necessary to clean the spray
arms regularly for hard water chemicals
will clog the spray arm jets and
bearings.
To remove the spray arms, screw
off the nut clockwise to take out the
washer on top of the spray arm and
remove the arm. Wash the arms in
soapy and warm water and use a soft
brush to clean the jets. Replace them
after rinsing thoroughly.

Содержание