Tp-Link TD-W8901G Инструкция по эксплуатации онлайн [33/73] 16819

TD-W8901G 54Mbps Wireless ADSL2+ Modem Router User Guide

Figure 4-11

¾ Router Local IP: These are the IP settings of the LAN interface for the device. These settings

may be referred to as Private settings. You may change the LAN IP address if needed. The

LAN IP address is private to your internal network and cannot be seen on the Internet.

• IP Address: Enter the Router’s local IP Address, then you can access to the Web-based

Utility via the IP Address, the default value is 192.168.1.1.

• IP Subnet Mask: Enter the Router’s Subnet Mask, the default value is 255.255.255.0.

• Dynamic Route: Select this option to specify the RIP (Routing Information protocol)

version for LAN interface, including RIP1, RIP2-B and RIP2-M. RIP2-B and RIP2-M are

both sent in RIP2 format, the difference is that RIP2-M using Multicast, while RIP2-B

using Broadcast format.

• Direction: Select this option to specify the RIP direction. None is for disabling the RIP

function. Both means the ADSL Router will periodically send routing information and

accept routing information, and then incorporate them into routing table. IN only means

the ADLS router will only accept but will not send RIP packet. OUT only means the ADLS

router will only send but will not accept RIP packet.

• Multicast: Select IGMP version, or disable the function. IGMP (Internet Group Multicast

Protocol) is a session-layer protocol used to establish membership in a multicast group.