D-Link DGS-3420-26SC [75/338] Create syslog host

DGS-3312SR Layer 3 Gigabit Switch

create syslog host

Parameters

<index 1-4> − Specifies that the command will be applied to an

index of hosts. There are four available indexes, numbered 1

through 4.

ipaddress <ipaddr> − Specifies the IP address of the remote host

where syslog messages will be sent.

severity − Severity level indicator. These are described in the

following:

Bold font indicates that the corresponding severity level is

currently supported on the switch.

Numerical Severity

Code

0 Emergency: system is unusable

1 Alert: action must be taken immediately

2 Critical: critical conditions

3 Error: error conditions

4 Warning: warning conditions

5 Notice: normal but significant condition

6 Informational: informational messages

7 Debug: debug-level messages

informational − Specifies that informational messages will be sent

to the remote host. This corresponds to number 6 from the list

above.

warning − Specifies that warning messages will be sent to the

remote host. This corresponds to number 4 from the list above.

all

−

Specifies that all of the currently supported syslog messages

that are generated by the switch will be sent to the remote host.