Whirlpool WBR 3012 S — установка, обслуживание и чистка свободностоящих приборов [26/31]

Превью страниц Страница 26 / 31

MAINTENANCE AND CLEANING

INSTALLATION

Freestanding appliances (not built-in)

• Fit the spacers (if supplied) on the rear of the

condenser positioned at the back of the appliance

(see figure); alternatively, leave a space of at least

6 cm between the rear of the appliance and the

wall.

• To optimize appliance efficiency, leave a 5 cm

gap above the appliance and make sure that

adjacent kitchen units are sufficiently distanced to

allow air circulation.

• Ensure that the appliance is level, using the front

adjustment feet if necessary.

• Regulations require that the appliance is earthed.

The manufacturer declines all liability for injury to

persons or animals and for damage to property

resulting from failure to observe the above

procedures and reminders.

• If the plug and socket are not of the same type,

have the socket replaced by a qualified

electrician.

Do not use extension leads or adapters.

Disconnecting the appliance

It must be possible to disconnect the appliance by

unplugging it or by means of a double-pole switch

isolating the socket.

Before any cleaning or maintenance operation, always unplug the appliance or disconnect it from the

power supply.

Periodically clean the refrigerator and freezer compartments with a sponge dampened in a solution of

lukewarm water and special detergent for refrigerator interiors. Rinse and dry. Never use abrasive

detergents. Never clean the refrigerator parts with flammable liquids. The fumes can create a fire hazard

or explosion.

• Clean the outside with a soft damp cloth.

Do not use abrasive products, scourers, stain-removers (e.g. acetone, trichloroethylene) or vinegar.

Dry with a soft cloth.

• Do not use steam cleaners.

• Regularly clean the condenser (air vents at the rear of the appliance) with a vacuum cleaner or a brush

(see figure).

• Ensure the seals are always perfectly clean.