Acme IA200 [15/152] Troubleshooting

troubleshooting

The iron emits a foul smell or gives o smoke

The iron may give o a bad smell when turned on for the rst time. Oil used for coating certain

parts during manufacture need to be burnt o. Allow ten minutes for the foul smell to disappear.

The iron does not heat

The iron should be plugged into electrical outlet. The thermostat dial must be set to the desired

temperature.

The iron does not produce steam

The water tank may be empty. Turn the steam control knob to required position and add water.

Allow the iron to heat and then set it to the “Steam” position.

The “Shot of steam” feature does not work

The water tank must be at least 1/4 full. The iron must be set to the “Steam” position. The iron

should be in the horizontal position. Prime the pump briey. Allow a short pause between shots.

Be sure to fully depress the “Shot of steam” button.

The “Water spray” feature does not work

The water tank must be at least 1/4 full. Fill the iron as described under “How to ll the water tank”.

Anti-drip function

1. Water supply is cut o automatically to prevent water from dripping from the soleplate when

the temperature of the iron is insucient to produce steam.

2. After plugging the iron into a mains outlet, wait for 3 minutes for steam to be produced.