Zkteco PL-852D23F-AM [12/42] Post power on self test

4 Operation

4.1 POST( Power On Self Test)

Speed dome will self test after power on. sequential execution: System preheat( if necessary), camera test, horizontal test, and tilt test. It

is about 40s to take self test.

Label：

1. Please confirm to the consistency of input power. Turn on switcher after make sure by connection of cable is OK.

2. Please stable voltage and less interference power supply. If it is necessary, please UPS to protect;

4.2 Reboot

Reboot device including software reboot and hardware reboot. Software reboot: Enter【device setting】>【Setting Tool】> 【Reboot】 :

Hardware reboot : Power off and Power on.

Instruction：

Power Failure Recovery：If the speed dome power off unusual when it is working, the previously video will be recorded and the speed

dome will be recovered as before after reboot.

4.3 Basically Operation

Following is operation which is combined with terminal equipment such as ( NVR, client software, etc.) It is usually operation, More

detail please refer to the manual of control system.

 Pan/Tilt: Move the joystick of keyboard to the expected direction; or press the direction key as UP, DOWN ,LEFT, RIGHT.

 ZOOM: Press Key of （TELE）from keyboard or DVR can zoom in; Press “(WIDE)” can zoom out.

 Focus: Press key of (Far) can make the nearby object clear and make defocus forane object, Press (NEAR) can make forane object

clear and defocus nearby object. In the auto fucous mode, the camera will focus automatically, And the manual fucous is available,

after the manual focus the camera will return to auto focus.

 Iris: Press Key of (OPEN) from keyboard and DVR can enlarge the iris, the Dig.ture will become to bright. The manual operation is

available in the auto IRIS mode, When the manual operation finish, the camera will return to auto IRSI mode. Press key (CLOSE)

can reduce the IRIS, the picture will become to dark.

 Preset: Speed dome support 255 presets, and some of presets are used for some special function.