Dometic CoolAir RT-IK для Renault T+C, H1 [21/280] Starting and ending configuration mode

CoolAir RT780 Configuration of unit software

8.1 Starting and ending configuration mode

The adjustable parameters can be changed in configuration mode:

➤ When using the button to switch on the unit, hold both buttons +

and

–

pressed until the compressor LED flashes.

✓ You are now in configuration mode.

✓ The display version (e. g. “3.1S”) appears in the display for 2 seconds.

✓ The first digit of the display shows the menu level and the second and third

digits show the parameters which can be set, e.g.

1.17 for menu level 1 and a

set target value of 17 °C.

➤ Press the button to quit configuration mode.

8.2 Menu level 1: Set temperature

The unit always starts with a defined value for the room temperature. This

parameter can be configured between 17 and 30 °C (62 and 86 °F).

➤ Start configuration mode (chapter “Starting and ending configuration mode”

on page 21).

✓ The first digit of the display shows the menu level and the second and third

show the parameter which can be set.

➤ Press the button to change the parameters.

➤ Use the +

and

–

buttons

to select the target value (in °C) at which the unit

should start operation.

✓ The digits in the display flash until the parameter you entered is confirmed.

➤ Press the button to confirm your entry.

✓ The set value is saved and is then used when the unit is restarted.

✓ You are now in menu level 1 again and can use the +

and

– buttons to switch

between menu levels.

NOTE

If you make no entry on the control panel for 60 seconds, the unit quits

configuration mode and shuts down.

RT780-Renault-H1--I-16s.book Seite 21 Mittwoch, 6. September 2017 5:31 17