Monsher TOP 60 B [10/32] Lighting

English

LIGHTING

LIGHT REPLACEMENT

Dismantle LED light module

• Remove the grease filter and carefully remove the 2 screws from the front plate

(a cross headed screwdriver will be needed to remove the screws).

• Disconnect the terminal of LED light.

• Press LED light on the back of the front plate, take the LED light out.

• Replace the lamp (commercially available LED lamp (max.1.5w).

Max Power Voltage Picture Lamp Cap ILCOS D code

Round/ Diameter:

70mm

1.5W DC 12 V -- DSR-1.5-S-70

Reinstall LED light module

• Press LED light on the front of front plate, install the LED light on the front plate.

• Connect the terminal of LED light and light leads.

• Carefully fasten the 2 screws on the front plate, reinstall the grease filter.

TROUBLE SHOOTING

Fault Cause Solution

Light on, but motor

does not work

The blades are blocked. Check the blades.

The capacitor is damaged. Replace capacitor.

The motor is damaged. Replace motor.

The internal wiring of motor

is cut off/ disconnected. An

unpleasant smell may be

produced.

Replace motor.