Monsher INNA 55 W [10/32] Compliance with current regulations and positioned in an accessible area after

Monsher INNA 55 W [10/32] Compliance with current regulations and positioned in an accessible area after
10
English
ELECTRICAL CONNECTION
The mains power supply must correspond to the rating indicated on the plate
situated inside the hood. If provided with a plug connect the hood to a socket in
compliance with current regulations and positioned in an accessible area, after
installation. If it not fitted with a plug (direct mains connection) or if the plug is
not located in an accessible area, after installation, apply a double pole switch
in accordance with standards which assures the complete disconnection of the
mains under conditions relating to over-current category III, in accordance with
installation instructions.
; Warning! Before re-connecting the hood circuit to the mains supply and
checking the efficient function, always check that the mains cable is correctly
assembled. The hood is provided with a special power cable ; if the cable is
damaged, request a new one from Technical Service.
MOUNTING
Very heavy product; hood handling and installation must be carried out by at
least two persons.
Before beginning installation:
• Check that the product purchased is of a suitable size for the chosen installation
area.
• Remove the charcoal (*) filter/s if supplied (see also relative paragraph). This/
these is/are to be mounted only if you want lo use the hood in the filtering version.
• Check (for transport reasons) that there is no other supplied material inside
the hood (e.g. packets with screws (*), guarantees (*), etc.), eventually removing
them and keeping them.
• If possible, disconnect and move freestanding or slide-in range from cabinet
opening to provide easier access to rear wall/ceiling. Otherwise put a thick, protective
covering over countertop, cooktop or range to protect from damage and debris.
Select a flat surface for assembling the unit. Cover that surface with a protective
covering and place all canopy hood parts and hardware in it.
• In addition check whether near the installation area of the hood (in the area
accessible also with the hood mounted) an electric socket is available and it is
possible to connect a fumes discharge device to the outside (only suction version).
• Carry out all the masonry work necessary (e.g. installation of an electric socket
and/or a hole for the passage of the discharge tube).
11English
Expansion wall plugs are provided to secure the hood to most types of walls/
ceilings. However, a qualified technician must verify suitability of the materials in
accordance with the type of wall/ceiling. The wall/ceiling must be strong enough
to take the weight of the hood. Do not tile, grout or silicone this appliance to the
wall. Surface mounting only.
OPERATION
Use the high suction speed in cases of concentrated kitchen vapours. It is
recommended that the cooker hood suction is switched on for 5 minutes prior
to cooking and to leave in operation during cooking and for another 15 minutes
approximately after terminating cooking.
To select the functions of the hood, simply touch the controls.
1. Stand by/ON display
2. ON/OFF suction speed (power) 1
ON/OFF suction speed (power) 2
ON/OFF suction speed (power) 3
3. ON/OFF lights
MAINTENANCE
; ATTENTION! Before performing any maintenance operation, isolate the hood
from the electrical supply by switching off at the connector and removing the
connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug
must be removed from the socket.

Содержание

Похожие устройства

Скачать