Zanussi FL 726 CN [6/39] Installation

INSTALLATION

Unpacking

You are advised to keep all transit devices so

that they can be refitted if the machine ever has

to be transported again.

1. Using a spanner, unscrew and remove the

rear right-hand bolt and lay the machine on

its back, taking care not to squash the hoses.

This can be avoided by placing one of the

corner packing pieces between the machine

and the floor.

2. Release the two plastic bags by removing the

adhesive strip.

3. Carefully remove the right-hand bag (1) then

the left-hand bag (2) by pulling them towards

the centre of the machine.

4. Set the machine upright and remove the two

remaining bolts from the back.

5. Pull out the three plastic spacers from the

holes into which the bolts were fitted.

6. Plug the open holes with the plugs which you

will find in the plastic bag containing the

instruction booklet.

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the

machine is not impeded by carpets, rugs etc.

Check that the machine does not touch the wall

or other kitchen units.

Carefully level by screwing the adjustable feet in

or out. Never place cardboard, wood or similar

materials under the machine to compensate for

any unevenness in the floor.

P0255

P0648

P0233

P0256

P0020

P1051

All transit bolts and packing must be

removed before using the appliance.