Elenberg WM-3610M [15/21] Positioning

screws (A) ﬁxed on the top cover, pull it forward and outwards.

Unscrew and remove the two nuts (B), remove the polystyrene then

replace the cover (C).

N.B. It is advisable to keep the packaging and transport holding

pieces in case the machine has to be transported again.

3. Positioning

Install the machine on a ﬁrm, ﬂat surface. Make sure that nothing

– carpets, cloths etc., can prevent the air from circulating around

the machine. Make sure that the machine is not touching a wall or

any piece of furniture as this would cause vibrations.

Level the machine by screwing the adjustable feet up or down; nev-

er place a piece of wood or any other object underneath to set off

any difference in height between one side and the other. Once the

machine is level, tighten the counter nuts on the feet.

4. Connecting to the water supply

The appliance may only be connected to the cold tap. Screw one

end of the cold water intake hose to the threaded connection point

at the back of the appliance and connect the other to the cold water

tap. The machine is designed to work with a water pressure of 0.5

to 10 bar. Check that the connections are watertight.

5. Emptying the water

The machine uses a pump to empty the water. The end of the ﬂex-

ible hose must be hung at a maximum height of 1 metre and mini-

mum 0.5 metres so the water can run off properly. Make sure there

are no kinks or snags in the runoff hose.

6. Electric connection

The machine is designed for use with 230V 50Hz. Connect the

machine to an earthed socket that complies with approved safety

standards. The makers refuse all responsibility in the event of dam-

age caused by failure to respect the security provisions.