Elenberg WM-3610M [16/21] Loading the machine

1. Loading the machine

Open the door and place the laundry in the drum, then close the

door ﬁrmly; the machine will not start if the door is not closed

properly.

2. Selecting washing programme

Choose the programme according to the type of fabric you are go-

ing to wash by referring to the programme list.

Attention: Never turn the button anticlockwise!

Turn the button so that the arrow points to the programme re-

quired; never point the arrow between two programmes.

3. Selecting washing temperature

Turn the temperature dial to the required position. If you want a

cold wash leave the button in the «0» position.

Do not exceed 40°C in the wool programme.

4. Selecting the function

If necessary, activate the special function button according to the

control pane.

N.B.: ANY FUNCTION BUTTONS THAT ARE NOT ACTIVATED MUST BE

IN THE NEUTRAL POSITION.

5. Dosing and adding washing products

Put the detergent and other products in the correct compartments.

Compartment 1 is used for washing powder, compartment 2 for

fabric softeners, whiteners, stain removers etc. When using pro-

grammes 1, 2 and 3, the fabric softener is run in during the ﬁrst

rinsing cycle to produce an anti-allergenic effect. If you want a

classic fabric softener rinsing cycle, pour the fabric softener into

compartment 2 and start the programme again in position 4. Make

sure you use a good quality detergent to avoid excessive foam.

6. Filling and starting the machine

Turn the water tap on full and check that there is no leaking.

Press the ON/OFF button to start the machine; it will run automati-

cally until the end of the cycle.

The machine will stop when the programme dial reaches the “ЃњЃh

position.

7. Unloading the machine

Press the ON/OFF button to set to the STOP position. Wait for two

minutes then push the button to open the door; remove the gar-

ments.

USING THE MACHINE