Dunlop M 88 Инструкция по эксплуатации онлайн

Dunlop M 88 Инструкция по эксплуатации онлайн
Congratulations on the purchase of your new M-88
MXR Bass Octave stomp box! MXR effects have been
favored by professional guitarists for decades. While
other effects have come and gone, MXR’s keep getting
the job done…with bulletproof construction, quiet,
reliable switching and tasteful, musically inspired tone
shaping.
This popular bass effect adds a deep note one octave below the note
you’re playing, for a huge, stadium-lling tone. The MXR Bass Octave
tracks instantly with what you’re playing, and continues to synthesize
useful subtones where other pedals give up.
The MXR Bass Octave lets you dial in a precise Dry and Octave mix
from subtle bass deepening, to smooth pedal tone doubling, to pure
sub-bass tones.
POWER
The Bass Octave pedal is shipped from the factory without a battery to prevent
possible damage from leakage. Batteries must be installed to operate the
Bass Octave unless and AC adapter used. When using batteries, the life of the
batteries can be greatly extended if you unplug the input when the effect is
not in use for long periods of time. The Bass Octave uses the Dunlop ECB03
Adapter (ECB03E for Europe), a 9-volt DC regulated AC adapter. Plug is positive
on barrel and negative in the center.
To install the battery, remove the four screws securing the bottom plate to the
pedal housing, attach the battery to the connector. Replace the bottom plate
and secure with the four screws.
SETUP
For initial settings, set the Dry control all the way up and the
Octave control to the middle position.
Run a shielded cord from your instrument’s output to the Bass
Octave’s input jack located on the right side of the pedal.
Run a shielded cord from your amplier’s input to the Bass
Octave’s output jack.
Turn on amplier and begin playing.
M-88
bass octave
Скачать