Home
Главная
Elenberg
Посудомоечная Машина
DW-600
Инструкция по эксплуатации Страница: 21

Elenberg DW-600 [21/24] Operating instructions

water comes out(this is very important when you use the dishwasher for the first

time) When you have added all the 500 grams of salt and water still does not come

out add slightly more water the salt indicator will go out after a few wash cycles.

Screw the cap back carefully.

Note: Load the salt before the beginning of wash cycle so as to prevent corrosion to

the tub.

Only special salt can be used for the dishwasher.

IMPORTANT: Your dishwasher is not a “garburator”. Clean off large particles of food

sediments before placing dishes in the dishwasher.

USING INTENSIVE WASH

The Intensive wash feature gives you the option of washing/drying dishes at very

high water temperatures. When activated, the intensive wash feature energizes a

heating element that will raise and maintain the internal water temperature of the

dishwasher at 69°С.

To operate the dishwasher:

1. Make sure the inlet and drain hoses are correctly and securely connected.

2. Push the door release button to open the door.

3. Place the dishes on the dish rack and cutlery inside the cutlery basket.

4. Check to make sure that the rotating spray arm can turn freely all the way round.

If necessary remove any obstacles.

5. Fill the detergent in the recessed area on inner door panel. (approx. 7 grams).

6. Close the door firmly

7. Open the water supply.

8. Press the power «On/Off» button. Press the button in then power light will light

on.

9. Select the desired program by press the program button. The program indicator

light will light on.

INTENSIVE NORMAL RAPID

10. The appliance will run about 3 seconds later and the program light will flash

during all the cycle.

11. At the end of the cycle the dishwasher will stop, the program light will stop

flashing and the dishwasher will beep for several seconds. Then the light will go

out.

12. The power light will not be off until the power «On/Off» button is switched off.

13. The dishwasher is designed to stop if the door is opened accidentally during

washing.

14. You may select another program during operation by pressing the «Prog./Start/

Reset» button over 3 seconds to cancel the program, then pressing the program

button to the desired program.

15. After washing, dishes should be allowed to cool down for about 15 minutes so

they are not too hot to handle. Dishes will cool quicker if the door is opened

slightly.

16. After unloading the dishwasher, remove the filter, clean off any bits of food, and

put the filter back in its position.

NOTE: Please do not open the door when dishwasher is running. The door could be

OPERATINg INSTRUCTIONS

Elenberg DW-600 [21/24] Operating instructions

Содержание

Похожие устройства