MPM MOP-18M Инструкция по эксплуатации онлайн [12/28] 463970

2. Stand the appliance on a ﬂat, stable and dry surface which is resistant to high temperatures.

NOTE! Bread may burn! Therefore the appliance must not be used near or below curtains and in vicinity of other

combustible materials!

NOTE! The working surfaces of the roaster are heated up to extremely high temperatures! Touch the holders

only!

USE OF THE ROASTER

NOTE! When opening the cover, proceed carefully owing to hot damp from the area under the heating panels!

1. Oil the heating plates (5) with butter, margarine or other fat.

2. Insert the plug into the power outlet. The red light (1) will go on to signal power.

3. Prepare the sandwiches.

4. The green indicator light (2) – thermostat will go on when the required temperature is

reached. Open the top lid by pulling the latch (4) , gently place the sandwiches on the bak-

ing trays. Close the lid carefully (3) and lock it by placing the latch into the lower part of the

device.

5. When checking the condition of sandwiches in course of their roasting, open the cover care-

fully owing to hot damp escaping from the both sides of the roaster!

6. Open the cover and remove roasted sandwiches using wooden or plastic spatula.

7. Before preparation of the next sandwiches, always close the cover in order to maintain re-

quired temperature. The green caution lamp (thermostat) will go on and oﬀ in course of

roasting to indicate that required temperature is maintained.

8. After ﬁnished roasting pull out the plug from the plug socket and allow the appliance to cool

completely.

NOTE! Do not use and metal and sharp knifes or forks, otherwise the damages of heating surfaces are possible!

CLEANING AND MAINTENANCE

1. Prior to commencing the cleaning (and after ﬁnishing the roasting), pull out the plug from

the plug socket and allow the appliance to cool completely.

2. For ease of cleaning, the heating plates (5) may be disassembled

using the buttons (6) and (7) located on the outer sides of the up-

per and bottom lid. To assemble the heating plates, place them into

the mounting holes located under the hinges of upper and bottom

plate (Fig. 1), and then press it gently against the lid.

3. Thoroughly wash the heating panels, clean the roaster edges using

soft cloth or towel.

4. If complete removal of any food residuals from the surface of heat-

ing panels is problematic, pour some edible onto dirty surface and

try to clean after about 5 minutes. Your eﬀorts will be successful this time.

5. Wipe the external surface of the roaster using wet cloth.

ATTENTION! Do not immerse the appliance in water or any other liquids! Do not wipe the inside of the appliance

with acute, abrasive cloths or sponges, as this can damage the heating surfaces!

Fig. 1