Qtech QSW-8200-52T-AC Команды для настройки портов онлайн [12/85] 481623

User Manual

Chapter 1. Commands for Network Port Configuration 12

www.qtech.ru

which affect the processing of other tasks, the port will be shut down to ensure the

normal processing of the switch.

 Example: Set the rate-violation of port 1/0/8-10 (GB ports) of the switch as 10000pps

and the port recovery time as 1200 seconds.

 Switch(config)#interface ethernet 1/0/8-10

 Switch(Config-Port-Range)#rate-violation 10000 recovery 1200

1.1.13 rate-violation control

 This command is not supported by the switch.

1.1.14 remote-statistics interval

 This command is not supported by the switch.

1.1.15 show interface

 Command: show interface [ethernet <interface-number> | port-channel <port-

channel-number> | loopback <loopback-id> | vlan <vlan-id> | tunnel <tunnel-id> |

<interface-name>] [detail]

 show interface ethernet status

 show interface ethernet counter {packet | rate}

 Function: Show information of layer 3 or layer 2 port on the switch

 Parameter: <vlan-id> is the VLAN interface number, the value range from 1 to 4094.

<tunnel-number> is the tunnel number, the value range from 1 to 50. <loopback-id> is

the loop back number, the value range from 1 to 1024. <interface-number> is the port

number of the Ethernet, status show important information of all the layer 2 ports.

counter {packet | rate} show package number or rate statistics of all layer 2 ports.

<port-channel-number> is the number of the aggregation interface, <interface-name>

is the name of the interface such as port-channel1. [detail] show the detail of the port.

 Command Mode: Admin and Configuration Mode.

 Default: Information not displayed by default

 Usage Guide: While for vlan interfaces, the port MAC address, IP address and the

statistic state of the data packet will be shown; for tunnel port, this command will show

tunnel interface state and the statistic state of control layer receives/sends tunnel data

packet, about the statistic data of physics interface receiving/sending data packet,

please refer to show interface ethernet command; for loopback port, this command will

show the interface statistic state of IP address and receiving/sending data packet; As

for Ethernet port, this command will show port speed rate, duplex mode, flow control

switch state, broadcast storm suppression of the port and the statistic state of the data

packets; for aggregated port, port speed rate, duplex mode, flow control switch state,

broadcast storm suppression of the port and the statistic state of the data packets will

be displayed. The information of all ports on the switch will be shown if no port is

specified.