Qtech QSW-8200-52T-AC [41/114] Dot1x portbased mode single mode

User Manual

Chapter 2. Commands for 802.1x 41

www.qtech.ru

 Switch(Config-If-Ethernet1/0/3)#dot1x max-user userbased 5

2.18 dot1x portbased mode single-mode

 Command: dot1x portbased mode single-mode

 no dot1x portbased mode single-mode

 Function: Set the single-mode based on portbase authentication mode; the no

command disables this function.

 Parameters: None.

 Command mode: Port Mode

 Default: Disable the single-mode.

 Usage Guide: This command takes effect when the access mode of the port is set as

portbase only. Before configuring the single-mode, if the port has enabled dot1x port-

method portbased command and exist online users, the switch will enforce all users of

this port are offline. After that, this port only allows a user to pass the authentication,

the user can access the specified network resource, but other authentication users of

this port will be denied and can not access the network. After disabling the single-

mode, the switch also enforce the authenticated user is offline.

 Example:

 Switch(Config-If-Ethernet1/0/1)#dot1x portbased mode single-mode

2.19 dot1x port-control

 Command: dot1x port-control {auto | force-authorized | force-unauthorized}

 no dot1x port-control

 Function: Sets the 802.1x authentication status; the “no dot1x port-control” command

restores the default setting.

 Parameters: auto enable 802.1x authentication, the port authorization status is

determined by the authentication information between the switch and the supplicant;

force-authorized sets port to authorized status, unauthenticated data is allowed to

pass through the port; force-unauthorized will set the port to non-authorized mode,

the switch will not provide authentication for the supplicant and prohibit data from

passing through the port.

 Command mode: Port configuration Mode

 Default: When 802.1x is enabled for the port, auto is set by default.

 Usage Guide: If the port needs to provide 802.1x authentication for the user, the port

authentication mode should be set to auto.

 Example: Setting port1/0/1 to require 802.1x authentication mode.

 Switch(config)#interface ethernet 1/0/1

 Switch(Config-If-Ethernet1/0/1)#dot1x port-control auto