Qtech QSW-8200-52T-AC — user Manual: Commands for Displaying Configuration Settings [14/25]

Превью страниц Страница 14 / 25

User Manual

Chapter 1. Commands for Show 14

www.qtech.ru

 Command mode: Admin Mode

 Usage Guide: When the user finishes a set of configuration and needs to verify the

configuration, show running-config command can be used to display the current active

parameters.

 Example:

 Switch#show running-config

1.20 show running-config current-mode

 Command: show running-config current-mode

 Function: Show the configuration under the current mode.

 Command mode: All configuration modes.

 Default: None.

 Usage Guide: Enter into any configuration mode and input this command under this

mode, it can show all the configurations under the current mode.

 Example:

 Switch(config-if-ethernet1/0/1)#show run c

 !

 Interface Ethernet1/0/1

 switchport access vlan 2

 !

1.21 show startup-config

 Command: show startup-config

 Function: Display the switch parameter configurations written into the Flash memory at

the current operation; those are usually also the configuration files used for the next

power-up.

 Default: If the configuration parameters read from the Flash are the same as the

default operating parameter, nothing will be displayed.

 Command mode: Admin Mode

 Usage Guide: The show running-config command differs from show startup-config in

that when the user finishes a set of configurations, show running-config displays the

added-on configurations whilst show startup-config won’t display any configurations.

However, if write command is executed to save the active configuration to the Flash

memory, the displays of show running-config and show startup-config will be the

same.

1.22 show switchport interface

 Command: show switchport interface [ethernet <IFNAME>]