Qtech QSW-8200-52T-AC [5/25] Logging executed commands

User Manual

Chapter 1. Commands for Show 5

www.qtech.ru

 Parameter: <ipv4-addr> is the IPv4 address of the host, <ipv6-addr> is the IPv6

address of the host; <local-number> is the recording equipment of the host with a valid

range of local0～local7, which is in accordance with the facility defined in the RFC3164;

<severity> is the severity threshold of the log information severity level. The rule of the

log information output is explained as follows: only those with a level equal to or higher

than the threshold will be outputted. For detailed description on the severity please

refer to the operation manual.

 Command Mode: Global Mode

 Default: No log information output to the log host by default. The default recorder of

the log host is the local0; the default severity level is warnings.

 Usage Guide: Only when the log host is configured by the logging command, this

command will be available. We can configure many IPv4 and IPv6 log hosts.

 Example 1: Send the log information with a severity level equal to or higher than

warning to the log server with an IPv4 address of 100.100.100.5, and save to the log

recording equipment local1.

 Switch(config)# logging 100.100.100.5 facility local1 level warnings

 Example 2: Send the log information with a severity level equal to or higher than

informational to the log server with an IPv6 address of 3ffe:506:1:2::3, and save to the

log recording equipment local5.

 Switch(config)# logging 3ffe:506:1:2::3 facility local1 level informational

1.5 logging executed-commands

 Command: logging executed-commands {enable | disable}

 Function: Enable or disable the logging executed-commands.

 Parameter: None.

 Command Mode: Global mode.

 Default: Disable state.

 Usage Guide: After enable this command, the commands executed by user at the

console, telnet or ssh terminal will record the log, so it should be used with the logging

LOGHOST command.

 Example: Enable the command and send the commands executed by user into log host

(10.1.1.1)

 Switch(Config)#logging 10.1.1.1

 Switch(Config)#logging executed-commands enable

1.6 logging loghost sequence-number

 Command: logging loghost sequence-number

 no logging loghost sequence-number