Qtech QSW-8200-28T-POEAC- DC Команды для протокола многоадресной рассылки онлайн [17/39] 481628

User Manual

Chapter 1. IPv4 Multicast Protocol 17

www.qtech.ru

 Default: No static mrouter port on VLAN by default.

 Usage Guide: When a port is a static mrouter port while also a dynamic mrouter port, it

should be taken as a static mrouter port. Deleting static mrouter port can only be

realized by the no command.

 Example: Switch(config)#ip igmp snooping vlan 2 mrouter-port interface

ethernet1/0/13

1.2.14 ip igmp snooping vlan mrouter-port learnpim

 Command: ip igmp snooping vlan <vlan-id> mrouter-port learnpim

 no ip igmp snooping vlan <vlan-id> mrouter-port learnpim

 Function: Enable the function that the specified VLAN learns mrouter-port (according

to pim packets), the no command will disable the function.

 Parameter: <vlan-id>: The specified VLAN ID, ranging from 1 to 4094.

 Command Mode: Global Mode

 Default: Enable

 Usage Guide: Enable the function that the specified VLAN learns mrouter-port

(according to pim packets). After a port received pim packets, it will be set to mrouter

port for implementing the automatic learning.

 Example: Disable the function that vlan 100 learns mrouter-port (according to pim

packets).

 Switch(config)#no ip igmp snooping vlan 100 mrouter-port learnpim

1.2.15 ip igmp snooping vlan mrpt

 Command: ip igmp snooping vlan <vlan-id> mrpt <value>

 no ip igmp snooping vlan <vlan-id> mrpt

 Function: Configure this survive time of mrouter port.

 Parameter: vlan-id: VLAN ID, ranging between <1-4094>

 value: mrouter port survive period, ranging between <1-65535>seconds

 Command Mode: Global mode

 Default: 255s

 Usage Guide: This command validates on dynamic mrouter ports but not on mrouter

port. To use this command, IGMP Snooping of this VLAN should be enabled previously.

 Example: Switch(config)#ip igmp snooping vlan 2 mrpt 100

1.2.16 ip igmp snooping vlan query-interval

 Command: ip igmp snooping vlan <vlan-id> query-interval <value>

 no ip igmp snooping vlan <vlan-id> query-interval

 Function: Configure this query interval.

 Parameter: vlan-id: VLAN ID, ranging between <1-4094>

 value: query interval, ranging between <1-65535>seconds

 Command Mode: Global mode