Qtech QSW-8200-28F-AC-DC — команды для настройки маршрутизации RIP в сетевых устройствах [31/74]

Превью страниц Страница 31 / 74

User Manual

Chapter 3. Commands for RIP 31

www.qtech.ru

specifies the name of interface to be applied with route filtering.

 Default: The function in default situation is disabled.

 Command Mode: Router mode and address-family mode

 Usage Guide: The filter will be applied to all the interfaces in case no specific interface is

set.

 Example: Switch# config terminal

 Switch(config)# router rip

 Switch(config-router)# distribute-list prefix myfilter in vlan 1

3.11 exit-address-family

 Command: exit-address-family

 Function: Exit address-family mode

 Command Mode: address-family mode

 Example: Switch(config)# router rip

 Switch(config-router)# address-family ipv4 vrf IPI

 Switch(config-router-af)# exit-address-family

 Switch(config-router)#

3.12 ip rip aggregate-address

 Command: ip rip aggregate-address A.B.C.D/M

 no ip rip aggregate-address A.B.C.D/M

 Function: To configure RIP aggregation route. The no form of this command will delete

this configuration.

 Parameter: A.B.C.D/M:IPv4 address and mask length.

 Command Mode: Router Mode or Interface Configuration Mode.

 Default: Disabled.

 Usage Guide: If to configure aggregation route under router mode, RIP protocol must

be enabled. If configured under interface configuration mode, RIP protocol may not be

enabled, but the aggregation router can operation after the RIP protocol be enabled on

interface.

 Example: To configure aggregation route as 192.168.20.0/22 globally.

 Switch(config)#router rip

 Switch(config-router) #ip rip agg 192.168.20.0/22