Qtech QSW-8200-28F-AC-DC [74/74] Show bfd neighbor

Превью страниц Страница 74 / 74

User Manual

Chapter 6. Commands for BFD 74

www.qtech.ru

 Example: Enable BFD for RIP on interface.

 s5(config-if-vlan50)#rip bfd enable

6.20 show bfd neighbor

 Command: show bfd neighbor [[<ipv6-address>|<ipv4-address] [details]]

 Function: Show BFD neighbor in switch.

 Parameter: <ipv6-address> specifies the shown neighbor shown of IPv6 address, <ipv4-

address> specifies the shown neighbor of IPv4 address, IP address refers to remote IP

address, details shows the detail information of neighbor.

 Default: None.

 Command Mode: Admin mode and configuration mode

 Usage Guide: Show BFD neighbor in switch.

 Example: Check the relevant information of BFD neighbor.

 s5#show bfd neighbor 50.1.1.1 details

 OurAddr NeighAddr LD/RD Detec Int(ms) State Interface

 50.1.1.5 50.1.1.1 1/1 2000 Up 3050

 Local Diag: 0, Poll bit: 0

 MinTx Int: 400(ms), MinRx Int: 400(ms), Multiplier: 5

 Received MinRxInt: 400(ms), Received MinTxInt: 400(ms), Received Multiplier: 5

 Local Act Trans Int: 400(ms), Remote Act Trans Int: 400(ms)

 Local Act Detec Int: 2000(ms)

 Registered protocols: RIP

 Echo state: Disable, Echo Detec Int(ms): 2000

 Multi Hop: No, Vrf Id: 0

 Recv Ctl Pkt Num: 631, Send Ctl Pkt Num: 630

 Recv Echo Pkt Num: 0, Send Echo Pkt Num: 0

 Last packet: Version: 1 - Diagnostic: 0

 Poll bit: 0 - Final bit: 0

 Multiplier: 5 - Length: 24

 My Discr: 1 - Your Discr: 1

 Min tx interval: 400(ms) - Min rx interval: 400(ms)

 Min Echo interval: 400(ms)