Fubag PG 950T [10/25] O m perator s anual

- 9 -

Checking bolts, nuts and screws

Renewing the engine oil

To prevent faults or breakdowns, carefully check all the nuts, bolts and screws on a daily basis.

Inspect the motor pump assembly before & after every start-up and usage.

Tighten any loose nuts or bolts.

Follow the environment protection instructions and drain the oil in a suitable container.

With the engine still hot, place a suitable container under the oil drain screw, then remove the oil

filler gauge plug and the oil drain screw.

After complete draining, screw the oil drain screw back on.

Top up with recommended oil then check the level.

Refit and tighten the oil filler gauge plug.

After filling, check that there are no oil leaks.

Wipe away any traces of oil with a clean cloth.

Warning: the cylinder head bolts must be tightened by a specialist. Refer to the agent for your

region.

N.B.: If necessary, a second black filler plug, but without a gauge, is available on the other side of the

engine.

Cleaning the sediment bow

Close the fuel tap.

Place a suitable container and a funnel underneath the

carburettors.

Unscrew the fuel drain plug (no. 1) to drain the fuel.

After draining, refit the fuel drain plug.

Remove the sediment bowl (no. 3) and the seal (no. 2).

Clean the sediment bowl (no. 3) with non-flammable

solvent or solvent with a high flash point. Dry it completely.

Refit the seal ( no. 2) and the sediment bowl (no. 3).

Open the fuel tap and check that there are no leaks.

www.fubag.ru

Omperator's anual