Home
Главная
Indesit
Стиральная Машина
W 431 TX
Инструкция по эксплуатации Страница: 24

Indesit W 431 TX [24/52] Technical characteristics

Model

W 431 TX

Dimensions

width 59,5 cm

height 85 cm

depth 53,5 cm

Capacity

from 1 to 5 kg

Electrical

connections

voltage 220/230 Volt 50 Hz

maximum absorbed power 2300 W

Water connections

maximum pressure 1 MPa (10 bar)

minimum pressure 0,05 MPa (0,5 bar)

drum capacity 42 litre

Spinning speed

up to 400 rpm

Control programs in

compliance with

IEC regulation 456

Cotton program:

Turn knob A to the "program 2"setting;

Turn knob B to the "60°C"setting.

This appliance conforms with the following E.E.C. directives:

- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications

- 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications

Too much foam.

Is the detergent appropriate

for machine washing?

Check whether the definition

on its label reads “for machine

wash” or “hand and machine

wash”, or any other similar

wording.

Is the correct amount being

used? An excessive amount

of detergent, besides

producing too much foam,

does not guarantee a more

effective wash, and causes

scaling in the internal parts of

the appliance.

If, despite all checks, the

washing machine fails to

function and the problem

persists, call your nearest

authorised Customer Service

Centre, providing the following

information:

- the nature of malfunction

- the model type no. (Mod. ....)

- the serial number (S/N ....)

This information can be found on

the data plate situated at the

back of the washing machine.

Is there space between the

machine and adjacent

units? If it is not a built-in

model, the washing machine

will oscillate a bit during the

spin cycle. A few cm of space

should therefore be left

around it.

The washing machine

leaks.

Is the metal ring of the inlet

hose properly attached?

Turn off the water supply,

unplug the appliance and try

tightening its attachment

without forcing it.

Is the detergent dispenser

obstructed? Remove and

wash it under tap water.

Is the drain hose well

attached? Turn off the water

supply, unplug the appliance

and try tightening its

attachment.

Is the drain hose kinked?

The tract of the drain hose

must be as straight as

possible. Make sure the drain

hose is not squashed or

kinked.

Is the washing machine’s

drain duct clogged? Is there

an extension of the drain

hose? If so, is it positioned

incorrectly, blocking the

water flow?

Excessive vibration

during the spin cycle.

Have all transit screws been

removed durind instal-

lation? See the following

page on installation

procedures.

Has the washing machine

been levelled correctly? The

levelling of the appliance

should be checked

periodically. Adjust the feet

and check them with a level.

The washing machine

does not drain or spin.

Does the selected

programme incorporates

water draining? Some

programmes stop at the end

of the wash cycles and

draining will have to be

selected manually.

Is the “Anti-crease"

function -where provided -

enabled? This function

requires manual selection for

draining.

Is the drain pump clogged?

To check it, turn off the water

supply, unplug the washing

machine and follow the

instructions on page 23, or

call for technical assistance.

Technical characteristics

Always get

assistance from

authorised

technicians and

always insist on

original spare parts.

Instructions for installation and use

Содержание

Похожие устройства

Is the drain hose kinked Is there space between the machine and adjacent units If it is not a built in The tract of the drain hose must be as straight as possible Make sure the drain hose is not squashed or kinked model the washing machine will oscillate a bit during the spin cycle A few cm of space should therefore be left around it Is the washing machine s drain duct clogged Is there an extension of the drain hose If so is it positioned incorrectly blocking the water flow The washing machine does not drain or spin Is the detergent appropriate for machine washing Does the selected programme incorporates water draining Some programmes stop at the end of the wash cycles and draining will have to be selected manually Too much foam Is the Anti crease function where provided enabled This function requires manual selection for draining The washing machine leaks Is the metal ring of the inlet hose properly attached Excessive vibration during the spin cycle I Is the drain pump clogged To check it turn off the water supply unplug the washing machine and follow the instructions on page 23 or call for technical assistance Always get assistance from authorised technicians and always insist on original spare parts Turn off the water supply unplug the appliance and try tightening its attachment without forcing it Have all transit screws been removed durind instal lation See the following page on procedures Is the detergent dispenser obstructed Remove and installation Has the washing machine been levelled correctly The levelling of the appliance should be checked periodically Adjust the feet and check them with a level wash it under tap water Is the drain hose well attached Turn off the water supply unplug the appliance and try tightening its attachment Technical characteristics Model W 431 TX Dimensions width 59 5 cm height 85 cm depth 53 5 cm Capacity from 1 to 5 kg Electrical connections voltage 220 230 Volt 50 Hz maximum absorbed power 2300 W Water connections maximum pressure 1 MPa 10 bar minimum pressure 0 05 MPa 0 5 bar drum capacity 42 litre Spinning speed up to 400 rpm Control programs in compliance with IEC regulation 456 Cotton program Turn knob A to the program 2 setting Turn knob B to the 60 C setting ff f This appliance conforms with the following E E C directives 73 23 EEC of 19 02 73 Low Voltage and subsequent modifications 89 336 EEC of 03 05 89 Electromagnetic Compatibility and subsequent modifications 21 Instructions for installation and use Check whether the definition on its label reads for machine wash or hand and machine wash or any other similar wording Is the correct amount being used An excessive amount of detergent besides producing too much foam does not guarantee a more effective wash and causes scaling in the internal parts of the appliance If despite all checks the washing machine fails to function and the problem persists call your nearest authorised Customer Service Centre providing the following information the nature of malfunction the model type no Mod the serial number S N This information can be found on the data plate situated at the backof the washing machine

Скачать

Случайные обсуждения

Ответы 1

Как очистить выходной фильтр?

6 лет назад

Ответы 1

подойдет ли дверной манжеь этой машинки на эндезит wg434txc r

8 лет назад

Ответы 1

Какой ремень подходит и размер ремня?

4 года назад

Ответы 1